Crescent SC2000 Manual de uso y mantenimiento - Página 2

Navegue en línea o descargue pdf Manual de uso y mantenimiento para Fregadora Crescent SC2000. Crescent SC2000 2 páginas. Scrubber-dryer

Imprimir página

ATTENTION! Do not use the machine before you have read and understood the Instructions for use manual.

External battery charger

1a. Unplug the Battery charger cable.

Reconnect it to the machine.

On board Battery charger

1b. Disconnect the battery charger

cable from the electrical socket.

6. Insert the operator key, then start

the machine by pressing the One-

Touch button.

11. Press the EcoFlex™ lever whenever

you temporarily need a greater

cleaning power.

16. Press the click-off button and wait

for the brush/pad holder to fall

on the ﬂoor. Remove to clean or

change brush.

If the machine has been used until the low battery level indicator on the machine, a full recharge of the batteries (10-12 hours) will be required. Failure to carry out this procedure may cause damage

to the batteries. Charging the batteries after every use is recommended.

PLEASE ENSURE THE CHARGER IS ALWAYS CONNECTED TO THE BATTERIES EVEN IF NOT USED FOR LONGER PERIOD OF TIME TO PREVENT DAMAGE TO THE BATTERY DUE TO LOW VOLTAGE

2. Fill the tank with a clean water. The

clean water temperature must not

exceed 40 °C.

Make sure the solution valve under

the machine is open.

7. To engage the brush, press the

brush click-on button.

At the end of the work

12.

Machine with Ecoﬂex, always end the daily

work with turning off the detergent 2 minutes

before ﬁnishing by pressing the detergent but

ton. To rinse out detergent from the system and

brush before handling and cleaning.

17. Take the squeegee off and remove

debris. Check and clean the squeegee

blades.

3. Fill the EcoFlex™ tank with a deter-

gent suitable for cleaning machines

(highly concentrated and low

foaming detergent).

8. Push the drive pedal to start cleaning.

Adjust the speed by the pressure on

the drive pedal.

For the reverse mode press the yellow

lever.

13. Empty the recovery tank with the

hose. Then empty the solution tank

with the transparent hose.

18. Clean the machine using a damp

cloth and where needed use a neu -

tral cleaning product.

4. Install the squeegee and fasten it

with the knob.

9. To change the solution ﬂow level

push the solution button and

change ﬂow level according to the

cleaning performance and applica -

tion.

14. Empty the debris tray and clean/

wash the recovery tank inside.

19. Charge the batteries: Connect the

battery charger cable to the electri -

cal socket.

www.crescentindustrial.co.uk

SC2000

5. Place the brush or the pad-holder

under the deck. Use the appropriate

brush to clean the ﬂoor.

10. If necessary press the extra pressure

function (hold for one second).

If necessary press the silent mode

button for extra low sound level.

15. Clean the ﬁlter:

A) Close the solu tion valve under the machine.

B) Remove the transparent cover and the gasket,

then remove and clean the ﬁlter inside.

C) Reassemble the ﬁlter.

20. Park the machine keeping the re -

covery tank cover open and hang -

ing the squeegee.