Accusplit 1690 Instrucciones de uso - Página 2

Navegue en línea o descargue pdf Instrucciones de uso para Podómetro Accusplit 1690. Accusplit 1690 2 páginas. Multi-function pedometer

Imprimir página

First, loop the

pedometer clip

Next, loop the metal

clip, then clasp clothing

Or, loop a belt

or belt loop

Attaching the Leash: Attach the pedometer to the leash by

looping the leash around the pedometer belt clip. Next, clasp

the waistband of your clothing with the attached metal clip. You

can also use a safety pin to fasten the leash to your clothing, or

loop the leash through your belt or belt loop.

VIEWING YOUR RESULTS

Once you put on your pedometer with the cover closed, it will

automatically begin to record your steps, distance, calories

burned, and activity time. Repeatedly press the yellow MODE

button to cycle through the pedometer modes:

STEPS → DISTANCE → CALORIES → ACTIVITY TIMER →

TIME OF DAY → STEPS

Please return your

AE1690 Registration to the Repair Center

address in the warranty, and we will let

you know about future products.

badge holder, then

put into pocket

(Badge holder

not included)

Email (preferred)

User

SCAN MODE

In Scan mode, the unit cycles through each of the display

modes (steps, distance, calories, clock, and activity time),

showing each one for five seconds. Press the cream SCAN

button to turn scanning on or off. The scan indicator (in the

bottom left-hand corner of display) will turn on to show when

you are in Scan mode.

AUTO MOVEMENT SENSOR

1. To filter out random movements, the unit remains in

standby mode until 5 continuous steps are registered. Only

then are the 5 steps calculated in, and an Active indicator

"▲" appears on the upper left of display.

2. When regular walk/run movement stops, after 2 seconds

the timer pauses and the unit switches to standby status

(Active indicator "▲" disappears).

Or, loop a

RESETTING YOUR PEDOMETER

Most people prefer to reset their pedometers daily. Press and

hold the green RESET button for at least two seconds to reset

steps, distance, calories, and activity time measurements

back to zero.

REPLACING THE BATTERY

When the display starts to dim or goes blank, it is time to

replace the battery. Your pedometer uses one Type LR43

(L1142) 1.5 volt alkaline battery. To replace:

1. Insert a coin into the slot on the bottom of the case, and twist

counterclockwise to loosen the case front. Lift case front away.

2. Using a pen or other thin object, push battery sideways out

of its holder. Replace it with a new battery. The battery's

positive (+) terminal should be FACE UP while you put it

into the pedometer.

3. Align case front over the pedometer and press gently to

snap cover back into place, starting with top.

NO-PROOF-OF-PURCHASE LIMITED WARRANTY

See label inside the lid of your pedometer