ABB SACE Emax 2 Manual - Página 2

Navegue en línea o descargue pdf Manual para Instrumentos de medida ABB SACE Emax 2. ABB SACE Emax 2 9 páginas. With aeg me1257-me2007-me2507-me3207 plug-in air circuit-breakers
También para ABB SACE Emax 2: Manual (5 páginas), Manual (7 páginas), Manual (6 páginas), Manual (6 páginas), Manual (5 páginas), Manual (4 páginas), Manual (4 páginas), Manual (6 páginas), Manual (4 páginas), Manual (7 páginas), Manual (6 páginas), Manual del usuario (10 páginas), Manual (15 páginas), Manual (4 páginas), Manual (6 páginas), Manual (5 páginas), Manual (15 páginas), Manual (4 páginas), Manual (12 páginas), Instrucciones de montaje (20 páginas), Manual (18 páginas), Manual del usuario (20 páginas), Manual (16 páginas), Manual de inicio rápido (7 páginas), Montaje (8 páginas), Manual (11 páginas), Sustitución (16 páginas), Manual (14 páginas), Manual (13 páginas), Manual del usuario (14 páginas), Manual de inicio rápido (5 páginas), Manual de funcionamiento preliminar (8 páginas), Manual (4 páginas), Manual de retroadaptación (16 páginas), Manual (11 páginas), Manual de retroadaptación (10 páginas)

MAKING THE SYSTEM SAFE FOR INSTALLATION

The following warnings and precautions must be respected before installing the CiC and circuit breaker in the

switchgear.

Ÿ Place the switchgear housing and the circuit breaker out of service.

Ÿ Disconnect the power from the switchgear (power circuit and auxiliary circuits) and verify it is disconnected

from all sources of energy.

Ÿ Set the obsolete circuit breaker to the open position with the springs unloaded.

Ÿ Double-check to ensure that the line has been placed out of service.

NOTE: The trained personnel in charge of handling and lifting must use appropriate safety equipment.

Tools Required:

All

1-1/4 inch

Open-end Wrench

10-15 inch long

Emax 2 Cradle in Cradle Installation Procedure

Remove the obsolete OEM circuit breaker.

•

Open the door of the switchgear.

•

Refer to the OEM installation manual for instructions to remove the breaker

from service.

WARNING: THE CIRCUIT BREAKER COULD DROP DURING THIS

OPERATION. BEFORE PROCEEDING REFER TO THE OEM MANUAL

FOR LIFTING AND REMOVAL INSTRUCTIONS AND USE

APPROPRIATELY SIZED AND RATED LIFTING DEVICE BEFORE

PROCEEDING .

•

(Optional) Disconnect and remove any auxiliary signaling or measuring

devices that will not be used with the new Emax 2 CiC.

•

Remove all the tools and equipment used for the operations and clean oﬀ

the processing residues and metal scraps.

All

Screwdrivers

1/4 inch

Flat-Blade

#1 Phillips

KP-800

KP-1600

KP-2000

Fig. 1