Diginet LEDsmart+ MMDM RT Manual - Página 8

Navegue en línea o descargue pdf Manual para Regulador de intensidad Diginet LEDsmart+ MMDM RT. Diginet LEDsmart+ MMDM RT 12 páginas. Setup functions

F: Setting Separate Switch Mode

The dimmer is designed to operate as a combined switch and dimmer, taking up only one gang in a wall plate.

However, some lamps (for example, non-dimmable CFL's) can flicker when switched OFF by pressing the rotary dial.

In these cases it is recommended that the dimmer is used in 'Separate Switch Mode' and combined with a standard

mechanical switch. Note this also applies where two way switching operation is required.

When used in the Separate Switch Mode, the dimmer turn-on level needs to be set. This is covered in Step 4 below.

Step 1

Enter into the dimmer Setup Mode - See PART A

Step 2

Click the dimmer rotary shaft six times

Step 3

LED will blink 6 times

Note: To cancel/exit do nothing for 30 seconds

Step 4

To Enable Separate Switch Mode

Adjust the dial Clockwise until the lamp(s) turn ON

Note the level the lamp(s) are adjusted to during this step will be the turn on level

when the separate switch is used during normal operation

To Disable Separate Switch Mode

Adjust the dial Anti-clockwise until the lamp(s) turn OFF (or pulses ON/OFF)

Note: To cancel/exit do nothing for 30 seconds

Step 5

Click once to save & exit

Note for Separate Switch Mode

• Clicking the rotary dial will toggle between the minimum level and the previous level

• 'Wake up' mode cannot be used

• LED indicators are always off when the separate switch is off

• The dimmer does not recall the previously set dimming level when switched back on. It

turns back on to level set in step 4 above.

Setup Functions - Rotary Dimmer/Switch