Diginet DGEMSR360P2 Manual de uso e instalación - Página 7
Navegue en línea o descargue pdf Manual de uso e instalación para Sensores de seguridad Diginet DGEMSR360P2. Diginet DGEMSR360P2 16 páginas. Recessed flush mount 360 pir presence sensor
Imprimir páginaDIGINET ENERGY MANAGEMENT
5.3.
Sensor Head
The sensor head is designed to be installed in plasterboard ceiling or ceiling tiles with a thickness of 10mm -
16mm thickness. A 52mm diameter cut-out is required to recess mount the sensor head. Figure 5 shows a cross
section of the sensor head installation. A cut-out template is on the presence sensor box for ease of making the
cut-out.
Figure 5 – Installation cross section of sensor head installed in plasterboard ceiling or ceiling tile.
Note: Avoid placing the sensor in positions close to hot or cold air vents and where the field of view
extends through doorways. This will reduce the risk of false triggering of the sensor.
The sensor head should be connected to the control module prior to pushing into the ceiling cut-out. Using a
screw driver, lift the tab on the control module (refer to Figure 6) to expose the 5 pin connector for the sensor
head. Using the supplied 5 core cable with pre-terminated connector, plug the sensor head onto the connector
and close the tab, ensuring the cable is gripped properly. The sensor head cable length is 450mm and if required,
can be extended to a maximum length of 1 metre.
Figure 6 – Lift tab to connect the sensor head to the control module.
Diginet Control Systems Pty Ltd
Recessed Flush Mount 360
Minimum 10mm
plaster board
o
PIR Presence Sensor
Page 7 of 16