Cisco 3020 - Cisco Catalyst Blade Switch Manual de introducción - Página 10

Navegue en línea o descargue pdf Manual de introducción para Interruptor Cisco 3020 - Cisco Catalyst Blade Switch. Cisco 3020 - Cisco Catalyst Blade Switch 37 páginas. Release notes for the cisco catalyst blade switch 3020 for hp, ciscoã‚â iosã‚â releaseã‚â 12.2(44)se
También para Cisco 3020 - Cisco Catalyst Blade Switch: Manual de introducción (31 páginas), Quickspecs (12 páginas), Nota de publicación (41 páginas), Nota de publicación (27 páginas), Nota de publicación (23 páginas), Nota de publicación (21 páginas), Manual de instalación (21 páginas)

Imprimir página

Cisco 3020 - Cisco Catalyst Blade Switch Manual de introducción

Before you run Express Setup, you must set up your switch module to communicate with a

Hyperterminal program.

The initial configuration assumes that the switch module was never configured, that it is in

Note

the same state as when it was received, and that it is not configured with a default username

and password.

To set up the switch module by using the command-line interface (CLI), see the switch module

Note

hardware installation guide on cisco.com.

Information You Need to Run Express Setup

You need this information about your switch module from your system administrator before you

complete the setup program:

• Fixed IP address

• Subnet mask (IP netmask)

• Default gateway IP address

You can also configure these optional parameters through the Express Setup program:

• Local access password

• Telnet access password

• Names of the SNMP read and write community strings if you are going to use a

network-management program like CiscoWorks.

• Host name, system contact, and system location

When you first set up the switch module, you can use Express Setup to enter the initial IP information.

Doing this enables the switch module to connect to local routers and the Internet. You can then access

the switch module through the IP address for further configuration.