Cisco 3020 - Cisco Catalyst Blade Switch Manual de introducción - Página 17

Navegue en línea o descargue pdf Manual de introducción para Interruptor Cisco 3020 - Cisco Catalyst Blade Switch. Cisco 3020 - Cisco Catalyst Blade Switch 31 páginas. Release notes for the cisco catalyst blade switch 3020 for hp, ciscoã‚â iosã‚â releaseã‚â 12.2(44)se
También para Cisco 3020 - Cisco Catalyst Blade Switch: Manual de introducción (37 páginas), Quickspecs (12 páginas), Nota de publicación (41 páginas), Nota de publicación (27 páginas), Nota de publicación (23 páginas), Nota de publicación (21 páginas), Manual de instalación (21 páginas)

Imprimir página

Cisco 3020 - Cisco Catalyst Blade Switch Manual de introducción

Figure 8

Advanced Settings Tab

In the Host Name field, enter a name for the switch module. The host name is limited to

Step 2

31 characters; embedded spaces are not allowed.

In the System Date and System Time fields, enter the current date and time, or use the down

Step 3

arrows to select them.

In the Time Zone field, use the down arrow to choose your time zone.

Step 4

Click Enable in the Daylight Savings Time field to enable this feature.

Step 5

In the Telnet Access field, click Enable if you are going to use Telnet to manage the switch

Step 6

module by using the CLI. If you enable Telnet access, you must enter a Telnet password.

If you plan to create a switch stack, enable Telnet access so that you can use the CLI

Note

to set this switch to the highest priority. See the "Planning and Creating a Switch

Stack (Only the Cisco Catalyst Blade Switch 3120 for HP)" section on page 23 for

more information about creating a switch stack.

In the Telnet Password field, enter a password. The Telnet password can be from 1 to 25

Step 7

alphanumeric characters, is case sensitive, allows embedded spaces, but does not allow spaces

at the beginning or end. In the Confirm Telnet Password field, re-enter the Telnet password.

Step 8

In the SNMP field, click Enable to enable Simple Network Management Protocol (SNMP).

Enable SNMP only if you plan to manage switches by using CiscoWorks 2000 or another

SNMP-based network-management system.