Resolved Caveats
•
Cisco IOS Caveats Resolved in Cisco IOS Release 12.2(50)SE
•
•
Note
•
•
•
•
•
•
•
•
Release Notes for the Cisco Catalyst Blade Switch 3020 for HP, Cisco IOS Release 12.2(50)SE and Later
16
CSCsy41470
The switch no longer runs out of memory when an smnpwalk, snmpget, or snmpbulkwalk is run on
the CISCO-ENERGYWISE-MIB.
CSCsq26873
The server no longer attempts re-authentication every ten minutes when a switch is configured with
the dot1x timeout reauth-period server interface configuration command.
CSCsq67398
Traffic is now forwarded to the interfaces that are configured with static multicast MAC addresses
after the switch is reloaded.
You cannot configure the static MAC address (unicast or multicast) entries on EtherChannel
member interfaces, or add an interface into the EtherChannel if that interface is associated with
a static MAC address entry.
CSCsq89564
If the switch uses 802.1x authentication with VLAN assignment, it no longer uses the VLAN
assignment with different authorization attempts, such as user authentication or re-authentication.
CSCsr50766
When keepalive is disabled on an interface, the interface is no longer put in an error-disabled state
when it receives keepalive packets.
CSCsr64007
The Switched Port Analyzer (SPAN) destination port no longer detects IPv6 multicast packets from
a VLAN that is not being monitored by SPAN.
CSCsr65689
This message no longer appears in the log during the system bootup on a switch that is running
Cisco IOS 12.2(50)SE:
CSCsu10065
When SFP ports are configured as status multicast router ports, IPv6 Multicast Listener Discovery
(MLD) snooping now works after the switch reloads.
CSCsu45951
A link is now established between a server and a switch when the server port is configured to not
autonegotiate the speed.
CSCsu59214
The
Set TxPortFifo SRR Failed
bandwidth shape 200 0 2 200 and the priority-queue out interface configuration commands on the
same interface.
CSCsu88168
The switch no longer reloads when the Forwarding Information Base (FIB) adjacency table is added.
message no longer appears when you enter both the srr-queue
OL-18274-02
Imprimir página