Cisco 3750 - Catalyst EMI Switch Manual de introducción - Página 22

Navegue en línea o descargue pdf Manual de introducción para Interruptor Cisco 3750 - Catalyst EMI Switch. Cisco 3750 - Catalyst EMI Switch 33 páginas. Catalyst 3750 series switches
También para Cisco 3750 - Catalyst EMI Switch: Ficha de datos (18 páginas), Manuales de instalación (47 páginas), Faq (10 páginas), Boletín de productos (5 páginas), Boletín de asistencia sobre productos (6 páginas), Productos (25 páginas), Descripción (1 páginas), Ficha de datos (23 páginas), Boletín de asistencia sobre productos (6 páginas), Manual de introducción (27 páginas), Ficha de datos (23 páginas)

In Case of Difficulty

If you experience difficulty, help is available in this section and also on Cisco.com. This section

includes Express Setup troubleshooting, how to reset the switch, how to access help online, and where

to find more information.

If Express Setup does not run, or if the Express Setup page does not appear in your browser:

• Did you verify that POST successfully ran

before starting Express Setup?

• Did you press the Mode button while the

switch was still running POST?

• Did you try to continue without confirming

that the switch was in Express Setup mode?

• Does your PC have a static IP address?

• Did you connect a crossover cable instead of

a straight-through Ethernet cable between a

switch port and the Ethernet port of the PC?

• Did you connect the Ethernet cable to the

console port instead of to a 10/100 or

10/100/1000 Ethernet port on the switch?

If not, make sure that only the SYST and STAT

LEDs are green before pressing the Mode button

to enter the Express Setup mode.

If yes, wait until POST completes. Power cycle the

switch. Wait until POST completes. Confirm that

the SYST and STAT LEDs are green. Press the

Mode button to enter Express Setup mode.

Verify that all LEDs above the Mode button are

green. (The RPS LED is off.) If necessary, press

the Mode button to enter Express Setup mode.

If yes, before connecting to the switch, change

your PC settings to temporarily use DHCP.

If yes, connect a straight-through cable to an

Ethernet port on the switch and the PC. Wait 30

seconds before you enter 10.0.0.1 in the browser.

If yes, disconnect the cable from the console port.

Then connect the cable to an Ethernet port on the

switch and the PC. Wait 30 seconds before you

enter 10.0.0.1 in the browser.