Cisco 4503 - Catalyst Switch Visión general - Página 22
Navegue en línea o descargue pdf Visión general para Interruptor Cisco 4503 - Catalyst Switch. Cisco 4503 - Catalyst Switch 46 páginas. Line cards
También para Cisco 4503 - Catalyst Switch: Descripción (2 páginas), Manual práctico (2 páginas), Ficha de datos (23 páginas)
Imprimir página
Ethernet and Fast Ethernet Switching Modules
WS-X4248-RJ21V
Figure 1-21 WS-X4248-RJ21V IEEE 802.3af-Compliant PoE 48-Port 10/100-Mbps Switching Module
1 2 3 4 5 6 7 8
9 10 11 12
13 14 15 16 17 18 19 20
Catalyst 4500 Series Module Installation Guide
1-22
The WS-X4248-RJ21V 48-port IEEE 802.3af-compliant PoE 10/100BASE-TX
RJ-21 switching module (see
Specification
Module type
Port duplex mode
Port speed
Number of ports
Connector type
Cable type
Power over Ethernet
Power regulation
21 22 23 24
25 26 27 28 29 30 31 32
33 34 35 36
To provide PoE with the 48-port PoE 10/100BASE-TX switching module in a
Catalyst 4006 switch, you must have a power entry module (PEM) and power
shelf installed. The Catalyst 4006 switch can provide 312 W per PoE module to
powered devices. If the powered devices are using the maximum 15.4 W per port,
there is only enough power for 18 powered devices. If the powered devices are
using less than 15.4 W per port, more powered devices can be powered, up to the
312 W maximum. For more information about installing the PEM or the external
power shelf, refer to the Catalyst 4000 Series Installation Guide, Catalyst 4500
Chapter 1
Figure
1-21) has the following specifications:
Description
10/100BASE-TX Fast Ethernet switching module
with IEEE 802.3af PoE
Half or full duplex mode
10 or 100 Mbps
48
RJ-21 (See
Figure 2-5 on page 2-5
page
2-5.)
Category 5 UTP
Up to 15.4 W per powered device on all 48 ports
(to a 312 W total on the Catalyst 4006)
Internal on the switching module
37 38 39 40 41 42 43 44
45 46 47 48
Module Overview and Specifications
or
Figure 2-6 on
78-13267-06