Cisco 7505 Manual de instrucciones de sustitución - Página 6
Navegue en línea o descargue pdf Manual de instrucciones de sustitución para Interruptor Cisco 7505. Cisco 7505 18 páginas. 600w ac-input power supply and fan tray replacement
También para Cisco 7505: Manual de instrucciones de sustitución (23 páginas), Manual de instrucciones de instalación (15 páginas), Manual de inicio rápido (32 páginas)
Imprimir página
Prerequisites
Prerequisites
Before you begin this installation, review the safety guidelines in this section to avoid injuring
yourself or damaging the equipment. This section also provides a list of the tools that you need to
perform this replacement.
Safety Guidelines
When working with any electrical equipment, the following guidelines will help to ensure your
safety and protect the equipment. This list is not inclusive of all potentially hazardous situations, so
be alert.
•
•
•
•
•
•
•
•
•
•
In addition, use the guidelines that follow when working with any equipment that is connected to
telephone wiring or other network cabling:
•
•
•
•
Opening the chassis and removing the power harness cover exposes the power distribution wiring
on the backplane. If the power is not shut down, the high current present on the backplane becomes
a hazard. Also, removing the cover compromises the electromagnetic interference (EMI) integrity
of the system. Therefore, always make sure that the system power switch is turned off before
removing the chassis cover panel or replacing any internal components.
6 600W AC-Input Power Supply and Fan Tray Replacement Instructions
Never try to lift an object that is too heavy for you to lift safely by yourself.
Keep tools and chassis components away from walk areas.
Do not work alone when potentially hazardous conditions exist.
Do not wear loose clothing, jewelry (including rings and chains), or other items that could get
caught in the chassis. Fasten your tie or scarf and sleeves.
Never install equipment that appears damaged.
Before beginning any procedures requiring access to the chassis interior, locate the emergency
power-off switch for the room in which you are working.
Disconnect all power and external cables before moving a chassis.
Never assume that power has been disconnected from a circuit; always check.
Do not perform any action that creates a potential hazard to people or makes the equipment
unsafe.
Carefully examine your work area for possible hazards such as moist floors, ungrounded power
extension cables, and missing safety grounds.
Never install telephone wiring during a lightning storm.
Never install telephone jacks in wet locations unless the jack is specifically designed for wet
locations.
Never touch uninsulated telephone wires or terminals unless the telephone line has been
disconnected at the network interface.
Use caution when installing or modifying telephone lines.