Cisco 9124 - mds multilayer fabric switch Nota de publicación - Página 9

Navegue en línea o descargue pdf Nota de publicación para Interruptor Cisco 9124 - mds multilayer fabric switch. Cisco 9124 - mds multilayer fabric switch 22 páginas. Mds 9000 series
También para Cisco 9124 - mds multilayer fabric switch: Especificaciones (2 páginas), Ficha de datos (9 páginas), Especificaciones (3 páginas), Manual de configuración (49 páginas), Nota de publicación (48 páginas), Nota de publicación (44 páginas), Nota de publicación (36 páginas), Nota de publicación (3 páginas), Nota de publicación (40 páginas), Manual (16 páginas), Manual de instalación del hardware (36 páginas)

IV. Enable In-Order Delivery of Frame

During a steady-state environment, the hardware and software architecture of the C-series

MDS 9000 Family prevents out-of-order (OOO) frame distribution from occurring. If the

fabric encounters a failure, some devices may not be able to handle any OOO frames. For

this reason, HP requires in-order delivery (IOD) be enabled for all switches. There is a

switch setting to enable in-order of frames during fabric failure.

Note: IOD feature is not supported on the MDS 9020.

Using the Management Console or Telnet to Enable IOD

Use the following procedure to enable in-order delivery (IOD) of frames with management

console or telnet:

1. Log into the switch using either the management console or telnet

2. Enter your network-admin privileged account by entering your login name and

password

switch login: admin

Password: <admin password>

3. Enter the following:

switch# show in-order-guarantee

4. The response shows whether or not in-order delivery is enabled



If the display shows

enabled and no other steps are required



If the display shows

disabled; continue to the next step

5. Enter into the configuration mode by entering the following command:

switch# config terminal

6. Enter the following command to set in-order delivery of frames:

switch(config)# in-order-guarantee

switch(config)# exit

7. Enter the following command to verify that in-order delivery is enabled:

switch# show in-order-guarantee

You should see the following response for all VSANs:

inorder delivery: guaranteed

8. Copy the running configuration into the startup configuration by entering the

following:

switch# copy running-config startup-config

Note: The running configuration overwrites the startup configuration.

IOD must be enabled for any additional VSANs created.

inorder delivery: guaranteed,

inorder delivery: not guaranteed,

MDS Multilayer Director & Multilayer Fabric Switches Release Notes

in-order delivery of frames is