Cisco AP776A - Nexus Converged Network Switch 5020 Nota de publicación - Página 27

Navegue en línea o descargue pdf Nota de publicación para Interruptor Cisco AP776A - Nexus Converged Network Switch 5020. Cisco AP776A - Nexus Converged Network Switch 5020 44 páginas. Cisco nexus 5000 series release notes release 4.1(3)n1(1) (ol-16601-01 h0, july 2009)
También para Cisco AP776A - Nexus Converged Network Switch 5020: Nota de publicación (48 páginas), Nota de publicación (26 páginas), Nota de publicación (22 páginas), Manual de consulta rápida (14 páginas), Nota de publicación (3 páginas), Nota de publicación (26 páginas)

Imprimir página
Cisco AP776A - Nexus Converged Network Switch 5020 Nota de publicación
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

Limitations and Restrictions

This section lists the limitations and restrictions for this release.
Upgrading to Recover Loss of Performance Manager Data
You must upgrade to Fabric Manager Release 3.1(x) and then upgrade to a later release of Fabric
Caution
Manager to avoid losing Performance Manager data. If data has been lost, follow the steps below to
recover the data.
Disable Performance Manager interpolation using Fabric Manager Web Client. Uncheck Interpolate
Step 1
missing statistics, then click Apply.
Stop the Fabric Manager Server.
Step 2
Save the data file in the $INSTALL_DIR directory.
Step 3
Move the old RRD file into the $INSTALL_DIR/pm/db directory.
Step 4
Step 5
Run $INSTALL_DIR/bin/pm.bat m.
Step 6
Restart Fabric Manager Server.
Maximum Number of Zones Supported in Interop Mode 4
In interop mode 4, the maximum number of zones that is supported in an active zone set is 2047, due to
limitations in the connected vendor switch.
When IVR is used in interop mode 4, the maximum number of zones supported, including IVR zones,
in the active zone set is 2047.
Upgrading the SAN-OS Software on the MDS 9222i Switch
On an MDS 9222i switch, an upgrade from SAN-OS Release 3.2(x), Release 3.3(1a), or Release 3.3(1c)
to SAN-OS Release 3.3(3) fails when there is an active FC-Redirect configuration (created by Cisco
SME or Cisco DMM applications) on the switch. An active FC-Redirect configuration is defined as:
FC-Redirect configuration for hosts or target connected locally
FC-Redirect configuration created by application running on that switch.
If an upgrade is attempted when an active configurations is present, the switch will go into a disruptive
upgrade.
OL-14116-11
Cisco MDS 9000 Family Release Notes for Cisco MDS SAN-OS Release 3.3(3)
Limitations and Restrictions
27