Cisco AP776A - Nexus Converged Network Switch 5020 Nota de publicación - Página 3

Navegue en línea o descargue pdf Nota de publicación para Interruptor Cisco AP776A - Nexus Converged Network Switch 5020. Cisco AP776A - Nexus Converged Network Switch 5020 26 páginas. Cisco nexus 5000 series release notes release 4.1(3)n1(1) (ol-16601-01 h0, july 2009)
También para Cisco AP776A - Nexus Converged Network Switch 5020: Nota de publicación (48 páginas), Nota de publicación (44 páginas), Nota de publicación (22 páginas), Manual de consulta rápida (14 páginas), Nota de publicación (3 páginas), Nota de publicación (26 páginas)

Cisco AP776A - Nexus Converged Network Switch 5020 Nota de publicación
S e n d d o c u m e n t a t i o n c o m m e n t s t o n e x u s 5 k d o c s @ c i s c o . c o m

Cisco Nexus 5010 Switch

The Cisco Nexus 5010 is a 28-port switch. It is a 1RU, 10-Gigabit Ethernet, Cisco Data Center Ethernet,
FCoE, and Fibre Channel switch providing more than 500-Gbps throughput with very low latency. It has
the following features:
For additional information about the Cisco Nexus 5010 switch see the Cisco Nexus 5000 Series
Hardware Installation Guide.
New and Changed Features in Cisco NX-OS Release
4.0(1a)N1(1a)
The new or changed features for this release are described in the following topics:
The shutdown lan Command
The DCBX protocol provides a capability to signal LAN Logical Link Status (LLS) to a CNA that is
connected to the Cisco Nexus 5000 switch over an Ethernet interface. This signaling can be used by the
bonding driver in the host to perform a failover to the standby link to the LAN.
The shutdown lan command provides the LAN administrator with the capability to trigger an
LLS-Down to the CNA. This operation can be performed without any impact to the SAN traffic on the
Ethernet interface. When the shutdown lan command is configured on an Ethernet interface, all VLANs
that are not enabled for FCoE are brought down on the interface. This in turn triggers the LLS-Down
signal. If non-FCoE VLANs are brought down by other means (like vlan shutdown) they trigger
LLS-Down signaling if the only VLANs active on an Ethernet interface are enabled for FCoE.
switch(config)# interface Ethernet 1/1
switch(config-if)# shutdown ?
<CR>
force
lan
switch(config-if)# [no] shutdown lan
OL-16601-01
Twenty fixed 10-Gigabit Ethernet, Cisco Data Center Ethernet, and FCoE SFP+ ports. Eight of the
twenty fixed ports support GE and 10GE speed.
One expansion module slot that can be configured to support up to 6 additional 10-Gigabit Ethernet,
Cisco Data Center Ethernet, and FCoE SFP+ ports, up to 8 Fibre Channel switch ports, or a
combination of 4 additional 10-Gigabit Ethernet, Cisco Data Center Ethernet, and FCoE SFP+ ports
with 4 additional 1/2/4-Gbps Fibre Channel switch ports.
Serial console port and an out-of-band 10/100/1000-Mbps Ethernet management port.
1+1 redundant, hot-pluggable power supplies.
1+1 redundant, hot-pluggable fan modules to provide highly reliable front-to-back cooling.
The shutdown lan Command, page 3
The errdisable recovery cause pause-rate-limit Command, page 4
Kickstart Break Sequence, page 4
Enable/disable an interface
Shut all LAN VLANs on interface

New and Changed Features in Cisco NX-OS Release 4.0(1a)N1(1a)

Cisco Nexus 5000 Series Release Notes, Release 4.0(1a)N1(1a)
3