Cisco BTS 10200 Manual del usuario - Página 22

Navegue en línea o descargue pdf Manual del usuario para Interruptor Cisco BTS 10200. Cisco BTS 10200 35 páginas. Softswitch

Imprimir página

Appendix A: Cable Labeling

Cables are labeled at both ends with the cable numbers listed in

attach the labels.

As listed in

Note

Make each label by copying the applicable number from

Step 1

number several times onto the label, as shown in

the labels for all cables in one print run.)

On a work bench or assembly table, position a cable so that one connector is on your left and the cable

Step 2

goes off to the right. (See

Attach the appropriate label to the cable as shown in

Step 3

Turn the cable around so that the other connector is on your left with the cable going off to the right.

Step 4

Repeat

Step 5

shown in

Repeat these steps for all cables in the rack, using the numbers from the cable list

Step 6

Figure 7

Connector

Figure 8

C I S C O C O N F I D E N T I A L

Table

1, some of the cables require labeling and others do not.

Figure

7.)

Step 2

and

Step 3

for this side of the cable. The completed cable should look like the example

Figure

Labeling Speciﬁcation

#16

Multiple rows on label, sufficient

#16

to ensure that label can be read

#16

without need to rotate or twist cable.

#16

Surface of connector that is flush

with rear panel when installed.

#16

1 inch

Completed Cable Example

#16

Table 1

Figure

7, to make it easier to read. (If desired, make

Figure

Cable

Label (example)

to match cable list

Table

1. Follow these steps to create and

onto the label. Be sure to duplicate the

(Table

1).

OL-2906-01