Cisco C3850-NM-4-1G Manual - Página 2

Navegue en línea o descargue pdf Manual para Interruptor Cisco C3850-NM-4-1G. Cisco C3850-NM-4-1G 15 páginas.
También para Cisco C3850-NM-4-1G: Instalación de (17 páginas)

Imprimir página

Installing a Network Module in the Switch

Network Module

C3850-NM-2-10G

C3850-NM-4-10G

C3850-NM-8-10G

C3850-NM-2-40G

Blank Network Module

Installing a Network Module in the Switch

Safety Warnings

This section includes the installation cautions and warnings. Translations of the safety warnings are available

in the Regulatory Compliance and Safety Information for Cisco Catalyst 9300 Series Switches.

Read this section before you install a network module.

Caution

Proper ESD protection is required whenever you handle equipment. Installation and maintenance personnel

should be properly grounded by grounding straps to eliminate the risk of ESD damage to the equipment.

Equipment is subject to ESD damage whenever you remove it.

Warning

Only trained and qualified personnel should be allowed to install, replace, or service this equipment. Statement

1030

Warning

Do not reach into a vacant slot or chassis while you install or remove a module. Exposed circuitry could

constitute an energy hazard. Statement 206

Installing a Network Module

Note

The switch can operate without a network module, but a blank module (with no ports or SFP slots) is available

and should be installed when uplink ports are not required.

Installing a Network Module

Description

This module has four slots. Two slots (left side) support only 1G SFP modules and

two slots (right side) support either 1G SFP or 10G SFP modules.

This module has four 10G slots or four 1G slots.

This module has eight 10G slots with an SFP+ port in each slot. Each port supports

a 1G or 10G connection

This module has two 40G slots with a QSFP+ connector in each slot.

Insert this blank module when the switch has no uplink ports (this is required for

sufficient air flow).

Installing a Network Module