Accustic Arts AMP I MK 2 Manual - Página 13

Navegue en línea o descargue pdf Manual para Reproductor de CD Accustic Arts AMP I MK 2. Accustic Arts AMP I MK 2 14 páginas.
También para Accustic Arts AMP I MK 2: Manual (10 páginas)

Imprimir página
Accustic Arts AMP I MK 2 Manual
6.6.7 A / B
The A / B function is also a repeat mode. You can use this key to repeat a certain passage of the track.
The A / B repeat mode is operated as follows:
1. During CD playback press the A / B key on the remote control just as the required passage begins
(start point A). In the display A – now appears.
2. When the end of the passage is reached (end point B), press the A / B key again and on the display
A – B now appears.
The device now plays the marked passage between points A and B again and again.
Pressing the A / B key again deactivates the repeat mode.
6.7 Dimmer function of blue LEDs
The two blue LEDs for STANDBY and OPERATE have an integrated dimmer function. That means the
LEDs will be automatically adapt to the brightness of your room.
7 Looking after your equipment
The DRIVE I – MK 2 from ACCUSTIC ARTS
care taken with high quality devices. Clean the housing with a dry or slightly moistened cloth. Please do
not use any aggressive detergents or detergents which contain silicon.
The best way to clean the front plate is with a mild non-aggressive fat-dissolving detergent (e.g. glass
cleaner). Never use abrasive agents or polishing agents with abrasive particles.
CAUTION!
Do not place the unit in direct sunshine and avoid extreme changes in
temperature.

8 Troubleshooting

Malfunctions are mostly caused by something simple which can be put right quickly.
In the next section some possible malfunctions are described together with their corrective action.
However, if it is not possible to remove the malfunction please contact your authorised dealer.
The unit was switched on, the blue LED 7 remains dark.
Malfunction
Cause 1
The mains cable is not properly connected.
Solution
Check mains cable and push in firmly.
Cause 2
The fuse is damaged.
Solution
Pull out the plug and replace the corresponding fuse.
Malfunction
The unit was switched on. The laser initialises, but shows
OPEN
The CD loader cover 11 was not properly closed during the switching on process.
Cause 1
Solution
Close CD loader cover; laser unit always initialises after each closing process.
®
does not require special treatment in excess of the usual
in the display.
14