FIBARO SWIPE FGGC-001 Manual de instrucciones - Página 5
Navegue en línea o descargue pdf Manual de instrucciones para Controlador FIBARO SWIPE FGGC-001. FIBARO SWIPE FGGC-001 13 páginas. Swipe gesture controller
Imprimir página
8
#4: Adding the device
Adding (Inclusion) - Z-Wave device learning mode, allowing to add
i
NOTE
the device to existing Z-Wave network.
Adding
in
security
To add the device to the Z-Wave network:
mode must be per-
formed up to 2 meters
1. Place the Swipe within the direct range of your Z-Wave controller.
from the controller.
2. Set the main controller in (security/non-security) add mode (see
the controller's manual).
i
NOTE
3. Move and hold your hand close to the center of the pad.
In case the device is
not added, please re-
set the device and re-
peat the adding pro-
cedure.
4. If the device is battery powered, high pitched beep will signal
exiting the Standby Mode.
5. Loud sound sequence will confirm entering the menu, keep
holding your hand.
6. After hearing two short beeps (green indicator colour), withdraw
the hand and perform swiping up gesture to confirm selection
(two beeps will confirm validity).
7. Wait for the adding process to end.
8. Successful adding will be confirmed by the Z-Wave controller's
message and 3 short beeps (green visual indicator colour).
ADDInG ThE DEvICE
#5: Removing the device
Removing (Exclusion) - Z-Wave device learning mode, allowing to
remove the device from existing Z-Wave network.
To remove the device to the Z-Wave network:
1. Place the Swipe within the direct range of your Z-Wave controller.
2. Set the main controller in remove mode (see the controller's
manual).
3. Move and hold your hand close to the center of the pad.
4. If the device is battery powered, high pitched beep will signal
exiting the Standby Mode.
5. Loud sound sequence will confirm entering the menu, keep
holding your hand.
6. After hearing two short beeps (green indicator colour), withdraw
the hand and perform swiping up gesture to confirm selection
(two beeps will confirm validity).
7. Wait for the removing process to end.
8. Successful removing will be confirmed by the Z-Wave controller's
message and sequence of 2 short beeps, pause, 1 short beep (red
visual indicator colour).
9
i
NOTE
Removing the Swipe
from the Z-Wave net-
work restores all the
default parameters of
the device.
i
NOTE
If the device is bat-
tery powered, high
pitched beep will sig-
nalize exiting from the
Standby Mode before
entering the menu.
REMOvInG ThE DEvICE