Digisol DG-GS4600SE2 Series Manual de instalación - Página 11
Navegue en línea o descargue pdf Manual de instalación para Interruptor Digisol DG-GS4600SE2 Series. Digisol DG-GS4600SE2 Series 20 páginas. Giga layer 3 switches
Imprimir página
Chapter 2 Hardware Installation
2.1 Installation Notice
To ensure the proper operation for DG-GS4600SE2 series and your physical security,
please read carefully the following installation guide.
2.1.1 Environmental Requirements
The switch must be installed in a clean area. Otherwise, the switch may be damaged
by electrostatic adherence.
Maintain the temperature within 0 to 50 °C and the humidity within 10% to 90%,
non-condensing.
The switch must be put in a dry and cool place. Leave sufficient spacing around the
switch for good air circulation.
The switch must work in the right range of power input (AC power: 90 ~
DC power: -40 ~ -60V)
The RPS input of the switch must be in the range of +11.5 ~ +13VDC.
The switch must be well grounded in order to avoid ESD damage and physical injury
of people.
The switch should avoid the sunlight perpendicular incidence. Keep the switch away
from heat sources and strong electromagnetic interference sources.
The switch must be mounted to a standard 19'' rack or placed on a clean level
desktop.
2.1.1.1 Dust and Particles
Dust is harmful to the safe operation of DG-GS4600SE2 series. Dust can lead to
electrostatic adherence, especially likely under low relative humidity, causing poor contact
of metal connectors or contacts. Electrostatic adherence will result in not only reduced
product lifespan, but also increased chance of communication failures. The recommended
value for dust content and particle diameter in the site is shown below:
Max Diameter (µm)
Max Density
(particles/m³)
DG-GS4600SE2 Installation Guide
0.5
1
5
5
1.4×10
7×10
Chapter 2-1
264V
3
5
5
2.4×10
1.3×10
(
,
50Hz)
5