Sharp 209H Manual de instrucciones - Página 5

Navegue en línea o descargue pdf Manual de instrucciones para Horno microondas Sharp 209H. Sharp 209H 24 páginas. Sharp m i c r o wav e o v e n operation manual

Imprimir página

U N PA C K I N G A N D I N S TA L L AT I O N I N S T R U C T I O N S

Unpacking and Examining Your Oven

Remove:

1. all packing materials from inside the oven

cavity; however, DO NOT REMOVE THE

WAVEGUIDE COVER, which is located on

Safety door latches

Door seals and

Waveguide

sealing surfaces

cover

Hinges

as misaligned or bent door, damaged door

seals and sealing surfaces, broken or loose

G R O U N D I N G I N S T R U C T I O N S

This appliance must be grounded. This oven is equipped with a cord having a grounding wire

with a grounding plug. It must be plugged into a wall receptacle that is properly installed and

grounded in accordance with the National Electrical Code and local codes and ordinances. In

the event of an electrical short circuit, grounding reduces risk of electric shock by providing an

escape wire for the electric current.

WARNING - Improper use of the grounding plug can result in a risk of electric shock.

Electrical Requirements

The electrical requirements are a 120 volt 60 Hz, AC only, 15

amp. or more protected electrical supply. It is recommended

that a separate circuit serving only this appliance be provided.

The oven is equipped with a 3-prong grounding plug. It must

be plugged into a wall receptacle that is properly installed and

grounded. Should you only have a 2-prong outlet, have a quali-

fied electrician install a correct wall receptacle.

A 3-prong adapter may be purchased and used temporarily if

local codes allow. Follow package directions.

A short power-supply cord is provided to reduce risk of becom-

ing entangled in or tripping over a longer cord.

Extension Cord

If it is necessary to use an extension cord, use only a 3-wire extension

cord that has a 3-blade grounding plug and a 3-slot receptacle that will

accept the plug on the microwave oven. The marked rating of the exten-

sion cord should be AC 115-120 volt, 15 amp. or more.

Be careful not to drape the cord over the countertop or table where it

can be pulled on by children or tripped over accidentally.

Notes:1. If you have any questions about the grounding or electrical

instructions, consult a qualified electrician or service person.

2. Neither Sharp nor the dealer can accept any liability for damage to the oven or personal

injury resulting from failure to observe the correct electrical connection procedures.

Radio or TV Interference

Should there be any interference caused by the microwave oven to your radio or TV, check

that the microwave oven is on a different electrical circuit, relocate the radio or TV as far

away from the oven as feasible or check position and signal of receiving antenna.

the right cavity wall.

Read enclosures

and SAVE the Op-

eration Manual.

2. the feature sticker,

if there is one, from

the outside of the

door.

Check the oven for

any damage, such

door hinges and latches and dents inside the

cavity or on the door. If there is any damage,

do not operate the oven and contact your

dealer or SHARP AUTHORIZED SERVICER.

Choosing a Location for Your Oven

You will use the oven frequently so plan its

location for ease of use. It's wise, if possible,

to have counter space on at least one side of

the oven. Allow at least 2 inches on the sides,

top and at the rear of the oven for air circula-

tion. Do not place or install the oven in any

area where heat and steam are generated; for

example, next to or above a conventional gas

or electric range or above a conventional wall

oven. Heat and steam may damage the elec-

tronics or the mechanical parts of the oven.