Sharp AX1200S - 22" SuperSteam Oven Manual de instrucciones de instalación - Página 4

Navegue en línea o descargue pdf Manual de instrucciones de instalación para Horno microondas Sharp AX1200S - 22" SuperSteam Oven. Sharp AX1200S - 22" SuperSteam Oven 8 páginas. Supersteam oven
También para Sharp AX1200S - 22" SuperSteam Oven: Manual de instrucciones (43 páginas), Especificaciones (2 páginas), Manual de instrucciones (43 páginas)

Imprimir página

STEP 1: CABINET OR WALL OPENING

Provide an opening in the wall or cabinet shown in Figure 1.

The depth should be minimum 23

plywood strong enough to support the weight of the oven (about 150 lbs., 68.1 kg) and should be level for

proper operation of the oven.

NOTE: While the proper functioning of the oven does not require that the opening be enclosed (with sides,

ceiling and rear partition), this may be required by local code, and it is suggested that the local code be

checked for any such requirement.

ELECTRICAL SUPPLY

At the rear of the opening, provide a 3 pronged, polarized, electrical outlet, 120 volt A.C., 15 amp. or larger.

This outlet should be located in the shaded area of Figure 1.

It is exceedingly important that the outlet be 120 volts and 15 amps. for optimum oven performance.

19" - 19

(482 mm - 486 mm)

STEP 2: INSTALLATION OF EXHAUST DUCT BOTTOM & DIVIDE PLATE L/R

It is recommended that a sheet of cardboard or other protective material should be placed on the table or

countertop to prevent damage to the surface during assembly.

1 Place DIVIDE PLATE L/R over 2 caches on EXHAUST DUCT BOTTOM.

2 Lock them into EXHAUST DUCT BOTTOM by sliding DIVIDE PLATE L/R in the direction of the

arrow as shown in Figure 2-A.

3 Tighten 4 SCREWS (A) from the bottom at the left and right sides as shown in Figures 2 and 2-A.

DIVIDE PLATE L

SCREW (A)

EXHAUST

DUCT BOTTOM

Figure 2

" (590.5 mm). The floor of the opening should be constructed of

2 3

m )

. 5 m

( 5 9 0

DIVIDE PLATE R

SCREW (A)

Figure 1

Figure 2-A

Catches

SCREW (A)