Sharp Carousel R-1510 Manual de instrucciones de instalación - Página 6
Navegue en línea o descargue pdf Manual de instrucciones de instalación para Horno microondas Sharp Carousel R-1510. Sharp Carousel R-1510 9 páginas. Over the range microwave oven
También para Sharp Carousel R-1510: Folleto y especificaciones (8 páginas), Manual de instrucciones de instalación (40 páginas), Manual de servicio (32 páginas), Manual (40 páginas)
Imprimir página
9
OVEN INSTALLATION
THIS OVEN CANNOT BE PROPERLY INSTALLED WITHOUT REFERRING TO THE MOUNTING INSTRUCTIONS FOUND ON
BOTH TEMPLATES.
THE NEXT STEP IS TO READ AND FOLLOW MOUNTING INFORMATION ON BOTH TOP CABINET AND WALL TEMPLATES.
NOTE: THIS OVEN SHOULD BE ATTACHED TO AT LEAST ONE WALL STUD. See WALL CONSTRUCTION on page 1.
MOUNTING SCALE PLATE
Attached 2 Scale Plates !, with tape (not included). See Figure 16 and WALL TEMPLATE for locations.
MOUNTING PLATE
1. Separate 4 Toggle Bolts 2, packed in the INSTALLATION HARDWARE, from the Toggle Nuts.
2. Match 5/8" holes (not in stud/s), drilled through WALL TEMPLATE into wall to corresponding holes on Mounting Plate.
3. Insert Toggle Bolts into matched openings on Mounting Plate. Put Toggle Nuts on Toggle Bolts. See Figure 17.
4. Position the Mounting Plate with the Toggle Bolts attached at the wall location and insert Toggle Nuts and Bolts through the
holes in the wall with the Toggle Nuts closed. Figure 18. Use Wood Screws 1 to attach the Mounting Plate to studs.
NOTE: Before insertion, be sure you leave a space more than the thickness of the wall between the Mounting Plate and the end
of each of the Toggle Nuts (in the closed position). If you do not leave enough space, the Toggle Nut will not be able to open on
the other side of the wall. Also, once a Toggle Nut opens, it cannot be withdrawn from the hole; therefore make sure all
of the Toggles are in the correct position before insertion.
4. Align the Mounting Plate carefully and hold in position while tightening Toggle Bolts. Pull Toggle Bolt toward you and turn
clockwise to tighten. Figure 19.
Figure 17
Mounting
Plate
Figure 16
Mounting Plate
Figure 18
Scale Plates
Space more than
wall thickness
Wall
6
Figure 19