Sharp Carousel R-3S56 Manual de servicio - Página 25

Navegue en línea o descargue pdf Manual de servicio para Horno microondas Sharp Carousel R-3S56. Sharp Carousel R-3S56 36 páginas.
También para Sharp Carousel R-3S56: Manual de instrucciones con libro de cocina (46 páginas)

Imprimir página

DOOR ADJUSTMENT

When removing and/or loosening hinges such as in door

replacement, the following adjustment criteria are taken.

Door is adjusted to meet the following three conditions by

keeping screws of hinge loose.

1. Adjust door latch heads at a position where they smoothly

catch the latch hook through the latch holes. Refer to

latch switch adjustments.

2. Deviation of the door alignment from horizontal line of

cavity face plate is to be less than 1.0mm.

3. The door is positioned with its face depressed toward

the cavity face plate.

4. Reinstall outer case and check for microwave leakage

around the door with an approved microwave survey

meter. (Refer to Microwave Measure ment Procedure.)

UPPER OVEN HINGE

RE-INSTALL

DOOR

ASSEMBLY

LATCH

HEADS

RE-INSTALL

Figure C-9. Door Assembly Replacement

and Adjustment

CHOKE COVER REMOVAL

1. Insert an iron plate(thickness of about 0.5mm) or flat

type screw driver to the gap between the choke cover

and door panel as shown figure to free the engaging

part.

2. Lift up the choke cover, now cover is free.

IRON

PLATE

Figure C-8. Choke Cover Removal

DOOR PARTS REMOVAL

Remove the door assembly, referring to from item 1 through

item 4 of "DOOR REPLACEMENT".

1. Place the door assembly on a soft cloth with facing up.

2. Remove the choke cover, referring to "CHOKE COVER

REMOVAL".

LATCH HEAD REMOVAL

3. Remove the door screen from the door frame.

4. Remove the four (4) screws holding the door frame to

the door panel.

SCREW

LOWER OVEN HINGE

SCREW

5. Remove the door frame from the door panel.

6. Release the latch spring from the tabs of the latch head.

7. Release the latch head from the door panel.

8. Now, the latch head is free.

SEALER FILM

Removal

1. Tear the sealer film from the door panel.

2. Now, the sealer film is free.

Installation

1. Put the adhesivetape on the backing film of the sealer

film as shown in Fig. 10.

2. Tear the backing film by pulling the adhesivetape.

3. Put the pasted side of the sealer film on the door panel.

Sealer film

Figure C-10. Sealer film

R-3S56

Backing film

Adhesive tape