Sharp Carousel R-880FS Manual de servicio - Página 31
Navegue en línea o descargue pdf Manual de servicio para Horno microondas Sharp Carousel R-880FS. Sharp Carousel R-880FS 48 páginas. Double grill convection microwave oven
También para Sharp Carousel R-880FS: Manual de servicio (3 páginas)
Imprimir página
• Make sure that the axis of the shaft is not
slanted.
3. Install the fan duct to the oven cavity rear plate with the
one (1) screw.
Coil
Groove joint pliers
Stator
Gap
Bracket
Rotor
Rear view
1. Disconnect the oven from the power supply.
2. Remove the turntable motor cover by snipping of
material in four corners.
3. Where the corners have been snipped off, bend corner
areas flat. No sharp edge must be evident after re-
moval of turntable motor cover.
4. Disconnect the wire leads from the turntable motor and
1. CARRY OUT 3D CHECKS.
2. Screw the oven lamp from the oven lamp socket off.
3. Pull the wire leads from the oven lamp socket by
pushng the terminal hole of the oven lamp socket with
the flat type screw driver.
4. Lift up the oven lamp socket from the air intake duct.
5. Now, the oven lamp socket is free.
Removal
1. CARRY OUT 3D CHECKS.
2. Remove the one (1) screw holding the green/yellow
wire to the cavity rear plate.
3. Disconnect the leads of the power supply cord from the
noise filter, referring to the Figure C-2(a).
4. Release the power supply cord from the oven cavity
rear plate.
5. Now, the power supply cord is free.
Oven Cavity
Back Plate
Screw
Brown Wire
Green/Yelow
L
Wire
Noise Filter
Figure C-2 (a) Replacement of Power Supply Cord
Shaft
Axis
Stator
Rotor
Side view
TURNTABLE MOTOR REPLACEMENT
OVEN LAMP REMOVAL
POWER SUPPLY CORD REPLACEMENT
Power Supply Cord
Bule Wire
Chassis
N
WHT
Support
RED
T1
T2
4. Insert the tabs of the capacitor holder to the fan duct.
5. Install the capacitor holder to the oven cavity rear plate
with the one (1) screw.
6. Install the noise filter to the fan duct and the chassis
support with the one (1) screw.
7. Re-connect the wire leads to the fan motor.
These are the positions
that should be pinched
with pliers.
Table
remove the two (2) screws holding the turntable motor.
5. Now, the turntable motor is free.
6. After replacement use the one (1) screw provided with
the turntable motor assembly to fit turntable motor
cover.
NOTE: The one (1) screw to fit the turntable motor cover
should be XHTSD40P08RV0.
Terminal
Wire lead
Flat type small
screw driver
Re-install
1. Insert the moulding cord stopper of power supply cord
into the square hole of the oven cavity rear plate,
referring to the Figure C-2(b).
2. Install the earth wire lead of power supply cord to the
cavity rear plate with one (1) screw and tight the screw.
3. Connect the brown and blue wire leads of power supply
cord to the noise filter correctly, referring to the Pictorial
Diagram.
Figure C-2(b). Power Supply Cord Replacement
29
Shaft
Center of
bracket
Oven lamp
socket
Terminal hole
Moulding
Cord Stopper
Power
Supply Cord
Oven Cavity
Rear Plate
Square Hole
R-880F(S)