Digistar 410002 Manual de instalación - Página 9

Navegue en línea o descargue pdf Manual de instalación para Instrumentos de medida Digistar 410002. Digistar 410002 9 páginas. Rotation counter for ez/tmr xx10 series indicators

Imprimir página

DEFAULT SETTINGS

SETTING

[display]

REMOTE INPUT 1

RMIMP1

TIMER,

COUNTER

TMRCTR

DRIVE RATIO

DRATIO

TESTING THE SYSTEM

1. With power applied to the circuit the Rotation Counter Status LED, as shown in Figure 3, will turn "On"

when the Rotation Counter Sensor is aligned with the steel target.

2. Continue to slowly turn the target away from the Sensor. If the sensor LED stays "On", move the Sensor

away from other metal objects. The target should light the Sensor Status LED only wither when PTO is

spinning, or when the target is directly in line with Sensor as shown in Figure 3.

3. Press TIMER/COUNTER.

4. Enter 20 (The number of rotations to count.)

5. Press TIMER/COUNTER

6. Indicator should display 20 REV

7. Engage PTO

8. Watch display to determine if the display counts down from 20.

9. Disengage PTO

10. Press CLEAR

IMPORTANT: Failure to install this system properly could result in Sensor and equipment damage. Please read

this document thoroughly before engaging PTO.

IMPORTANT: Failure to keep sensor clear of dirt and debris could result in sensor and equipment damage.

The installation diagrams show safety shields removed in order to show additional details. Never

operate equipment without safety shields in place. Adding the target to a rotating shaft may require additional

shielding and is not provided. Consult your original equipment manufacturer.

D4044

Rotation Counter Installation Manual for EZ/TMR xx10 Series Indicators

OPTIONS [displayed]

D.A.N NO.

BOLD=DEFAULT

MENU 5. CONTROL SETTINGS

1401

TARE, PRINT, HOLD,

(402)

NETGRS, M+, ZERO,OFF,

PRESET, SWITCH, MIXCTR

TIMER, COUNTER

4301

(421)

1.0

4302

(422)

DESCRIPTION

Set function of Remote Input line.

Change to MIXCTR when utilizing

Rotation Counter.

Select Time or Mixer Revolutions

to decrement mix

TIMER/COUNTER. Change to

COUNTER when utilizing

Rotation Counter.

Unless directly measuring mixer

rotor or auger (1:1), enter the

number of input pulses that equal

1 revolution of the rotor or auger.

(Example: If 1000 RPM Tractor

PTO speed equals 20 RPM of the

mixing auger make this setting

50.0)

Default Settings