DIGISYNTHETIC DS100 Manual de instrucciones - Página 6
Navegue en línea o descargue pdf Manual de instrucciones para Equipos de grabación DIGISYNTHETIC DS100. DIGISYNTHETIC DS100 15 páginas. 24-bit digital dual engine multi-effect processor
Imprimir páginaprogram change information is received on.
This button selects the Engine B effect module. Once this button has been pressed, use the
15)Engine B-
-gram/Data> wheel to change the effect used in the module.
16)Store Button-This button is used to store program modifications in the DS100.
2. The Rear Panel
1)AC Line Input-This is the AC adapter receptacle. Before you connect the unit, please make sure that the
displayed voltage corresponds to your Mains supply.
2)MIDI IN-This MIDI jack is used for receiving MIDI program change and CC information.
3)Footswitch Jack-This Jack is used for the insertion of the Digitech FS-300 footswitch that will control pro
-gram changes and Bypass the digital effects of the DS100.
4)Right Output-This is the DS100's right audio output. Use both left and right outputs to take advantage of
stereo effects.
5)Right Input Level-This knob controls the level of signal entering the DS100 from right. For optimal perfor
-mance, set this level so the Input level indicators(located on the front panel) occasionally
light the red LEDs.
6)Right Input-This is the Right Input jack for the DS100 that when used with Left input will preserve stereo
imaging.
7)Left/Mono Input-This Input jack is used for the Left or Mono input. When only the Left input jack is used,
the signal is sent to both Left and Right DS100 inputs.
8)Left Input Level-This knob controls the level of signal entering the DS100 from left. For optimal performance,
set this level so the Input level indicators(located on the front panel) occasionally light the
red LEDs.
9)Left/Mono Input-This Input jack is used for the Left or Mono input. When only the Left input jack is used,
the signal is sent to both Left and Right DS100 inputs.
3. Operation and Editing
This section will provide you with ll of the information necessary to get the most out of your DS100.
3.1 Program Mode
Page 5
FUSE:
REPLACE WITH SAME TYPE FUSE AND RATING
ATTENTION:
RISK OF ELECTRIC SHOCK
DO NOT OPEN THE COVER OR BACK
160-250VAC: T125mA
MIDI IN
FOOTSWITCH
RIGHT OUT
RIGHT IN LEVEL
ALL INPUTS & OUTPUTS
FULLY BALANCED
TIP/PIN2
20dB
4dB
RING/PIN3
SLEEVE/PIN1
SERIAL NUMBER
DATE CODE
RIGHT IN
LEFT/MONO OUT
LEFT IN LEVEL
LEFT/MONO IN
20dB
4dB
<Pro