Sharp CD-BA2600H Manual de instrucciones - Página 39
Navegue en línea o descargue pdf Manual de instrucciones para Sistema estéreo Sharp CD-BA2600H. Sharp CD-BA2600H 42 páginas. Mini component system
También para Sharp CD-BA2600H: Manual de instrucciones (5 páginas)
Troubleshooting Chart
Many potential "problems" can be resolved by the owner without calling a service
technician.
If something is wrong with this product, check the following before calling your autho-
rised SHARP dealer or service centre.
„ General
Symptom
z The clock is not on time.
z When a button is pressed, the unit
does not respond.
z No sound is heard.
„ CD player
Symptom
z Playback does not start.
z Playback stops in the middle or is
not performed properly.
z Playback sounds are skipped, or
stopped in the middle of a track.
„ Tuner
Symptom
z Radio makes unusual noise con-
secutively.
Possible cause
z Did a power failure occur? Reset the
clock. (Refer to page 11.)
z Set this unit to the power stand-by mode
and then turn it back on.
z If the unit still malfunctions, reset it. (Refer
to step 3 under "If trouble occurs" on page
34.)
z Is the volume level set to "0"?
z Are the headphones connected?
z Are the speaker wires disconnected?
Possible cause
z Is the disc loaded upside down?
z Does the disc satisfy the standards?
z Is the disc distorted or scratched?
z Is the unit located near excessive vibra-
tions?
z Is the disc very dirty?
z Has condensation formed inside the unit?
Possible cause
z Is the unit placed near the TV or comput-
er?
z Is the FM aerial or AM loop aerial placed
properly? Move the AC power lead away
from the aerial if located near.
„ Cassette deck
Symptom
z Cannot record.
z Cannot record tracks with proper
sound quality.
z Cannot erase completely.
z Sound skipping.
z Cannot hear treble.
z Sound fluctuation.
z Cannot remove the tape.
„ Remote control
Symptom
z The remote control does not oper-
ate.
„ Condensation
Sudden temperature changes, storage or opera-
tion in an extremely humid environment may
cause condensation inside the cabinet (CD pick-
up, tape heads, etc.) or on the transmitter on the
remote control.
Condensation can cause the unit to malfunction.
If this happens, leave the power on with no disc
(or cassette) in the unit until normal playback is
possible (about 1 hour). Wipe off any condensa-
tion on the transmitter with a soft cloth before op-
erating the unit.
Possible cause
z Is the erase-prevention tab removed?
z Is it a normal tape? (You cannot record on
a metal or CrO tape.)
z Is there any slack?
z Is the tape stretched?
z Are the capstans, pinch rollers, or heads
dirty?
z If a power failure occurs during playback,
the heads remain engaged with the tape.
Do not open the compartment forcibly.
Wait until electricity resumes.
Possible cause
z Is the AC power lead of the unit plugged
in?
z Is the battery polarity respected?
z Are the batteries dead?
z Is the distance or angle incorrect?
z Does the remote control sensor receive
strong light?
ENGLISH
E-33