Sharp CD-SW200 Manual de instrucciones - Página 39

Navegue en línea o descargue pdf Manual de instrucciones para Sistema estéreo Sharp CD-SW200. Sharp CD-SW200 44 páginas. Sharp cd-sw200 cd players: quick start
También para Sharp CD-SW200: Manual de inicio rápido (2 páginas)

Imprimir página

Headphones

Before plugging in or unplugging the headphones, reduce the vol-

ume.

Be sure your headphones have a 1/8" (3.5 mm) diameter plug and

impedance between 16 and 50 ohms. The recommended imped-

ance is 32 ohms.

Plugging in the headphones disconnects the speakers automati-

cally. Adjust the volume using the VOLUME control.

Troubleshooting chart

Many potential problems can be resolved by the owner without call-

ing a service technician.

If something is wrong with this product, check the following before

calling your authorised SHARP dealer or service centre.

General

The clock is not set to the

correct time.

When a button is pressed,

the unit does not respond.

CD-SW200

No sound is heard.

CD player

Playback does not start.

Playback stops in the mid-

dle or is not performed

properly.

Playback sounds are

skipped, or stopped in the

middle of a track.

Symptom

Possible cause

Did a power failure occur? Reset

the clock. (Refer to page 16.)

Set the unit to the power stand-

by mode and then turn it back on.

If the unit still malfunctions, reset

it. (Refer to page 41.)

Is the volume level set to "0"?

Are the headphones connected?

Are the speaker wires discon-

nected?

Symptom

Possible cause

Is the disc loaded upside down?

Does the disc satisfy the stan-

dards?

Is the disc distorted or

scratched?

Is the unit located near excessive

vibrations?

Is the disc very dirty?

Has condensation formed inside

the unit?

CD-SW200