Sharp AR-M450 Imager Manual de instrucciones - Página 10

Navegue en línea o descargue pdf Manual de instrucciones para Impresora todo en uno Sharp AR-M450 Imager. Sharp AR-M450 Imager 32 páginas. Ar-m280 | ar-m350 | ar-m450 operation manual (for network scanning)
También para Sharp AR-M450 Imager: Folleto y especificaciones (11 páginas), Manual de piezas (30 páginas), Manual de recarga (8 páginas), Manual de instrucciones (40 páginas)

Imprimir página
Sharp AR-M450 Imager Manual de instrucciones

SENDING AN IMAGE

BASIC TRANSMISSION METHOD

1
Make sure the machine is in scanner mode.
2
Load the original.
NOTE
You cannot load documents in both the auto document
feeder and on the document glass and send them in a
single transmission. If documents are loaded in both the
auto document feeder and on the document glass, only
the document in the auto document feeder will be scanned
and transmitted.
3
Check the original size.
STANDARD
RESOLUTION
AUTO
8 X11
1 /
2
ORIGINAL
NOTE
To scan a two-sided original or use the verification stamp
function (if the optional verification stamp unit is installed),
refer to pages 11 and 12.
4
If needed, adjust the resolution setting.
(Refer to page 14.)
STANDARD
RESOLUTION
AUTO
8 X11
1 /
2
ORIGINAL
8
When the IMAGE SEND
key light is on, the machine
is in scanner mode. If the
light is not on, press the
IMAGE SEND key.
For detailed information on
loading an original, refer to
pages 7 and 8 of "Operation
manual (for copier)".
The
original
size
is
automatically detected.
If you loaded a non-standard
size document or wish to
change the scanning size,
touch the ORIGINAL key
and set the document size.
(Refer to page 13.)
The initial factory setting is
STANDARD.
5
If needed, adjust the exposure setting.
(Refer to page 15.)
AUTO
EXPOSURE
STANDARD
RESOLUTION
AUTO
8 X11
1 /
2
ORIGINAL
6
Touch the SENDER LIST key.
DIRECTORY
ADDRESS REVIEW
-MAIL ADDRESS
SENDER LIST
NOTES
• You can omit selection of a sender (go directly to step
11). In this case, the default sender information stored
with the key operator program is automatically
transmitted. (Page 27)
• Up to 20 senders can be stored using the Web page.
(Page 5)
7
Touch a key to select a sender.
DER LIST
SHARP PPD
1 GROUP
2 GROUP
8
Touch the OK key.
1 GROUP
The initial factory setting is
AUTO.
This step is not necessary
for Scan to FTP or Scan to
Desktop. Go directly to step
9 (next page).
The
touched
key
is
highlighted. If you made a
mistake, touch the correct
key. The highlighting will
move to the new key.
The selected sender will be
the sender of the e-mail.