Sharp MX-3111U Manual de configuración del software - Página 9

Navegue en línea o descargue pdf Manual de configuración del software para Impresora todo en uno Sharp MX-3111U. Sharp MX-3111U 46 páginas. Sharpdesk mobile operation manual
También para Sharp MX-3111U: Manual de inicio (28 páginas), Manual de instrucciones (48 páginas), Manual de inicio rápido (1 páginas), Manual de inicio rápido (1 páginas), Manual de inicio rápido (1 páginas), Manual de inicio rápido (28 páginas), Manual de inicio rápido (1 páginas), Manual de inicio (24 páginas), Garantía (2 páginas), Manual de instrucciones (19 páginas), Especificaciones (1 páginas)

CONNECTING THE MACHINE

To connect the machine to a network, connect the LAN cable to the machine's network connector. Use a shielded LAN

cable.

After connecting the machine to a network, be sure to configure the IP address and other network settings before

installing the software. (The factory default setting for the IP address is to receive the IP address automatically when the

machine is used in a DHCP environment.)

Network settings can be configured using "Network Settings" in the system settings (administrator) on the machine.

• If the machine is used in a DHCP environment, the IP address of the machine may change. If this happens, printing will not

be possible. This problem can be avoided by using a WINS server or by assigning a permanent IP address to the machine.

• This manual explains how to set up the software in a Windows network environment and in a Macintosh network

environment.

• When using this machine on an IPv6 network, enable IPv6 setting in the "Network Settings" in the system settings

(administrator).

Checking the IP address of the machine

You can check the IP address of the machine by printing out the "NIC Page" in the system settings. Follow these steps

to print out the "NIC Page".

Press the [SYSTEM SETTINGS] key, touch the [List Print (User)] key, select "NIC Page" from "Printer Test Page" and

then touch the [Print] key.

CONNECTING THE MACHINE WITH A USB CABLE

(Windows)

The machine can be connected to a computer using a USB cable if the computer is a Windows computer. (The USB

interface on the machine cannot be used in a Macintosh environment.)

The machine and computer should be connected while the printer driver is being installed. If a USB cable is connected

before the printer driver is installed, the printer driver will not be installed correctly. For the procedure for connecting a

USB cable, see "WHEN THE MACHINE WILL BE CONNECTED WITH A USB CABLE" (page 18).