Sharp Plasmacluster SJ-F750SP Manual de instrucciones - Página 10

Navegue en línea o descargue pdf Manual de instrucciones para Frigorífico Sharp Plasmacluster SJ-F750SP. Sharp Plasmacluster SJ-F750SP 21 páginas.
También para Sharp Plasmacluster SJ-F750SP: Manual de instrucciones (12 páginas)

Imprimir página

CARE AND CLEANING

WARNING

Unplug the refrigerator first to prevent electric

■

shock.

Do not splash water directly on the outer cabinet

■

or the interior. This may lead to rusting and

deterioration of the electrical insulation.

IMPORTANT

To prevent cracking on inside surfaces and plastic

components, follow these tips.

• Wipe any food oils adhered to plastic components.

• Some household chemicals may cause damage, so use

only diluted washing-up liquid (soapy water).

• If undiluted detergent is used or soapy water is not wiped

off thoroughly, cracking of plastic parts can result.

Remove the shelves and pockets from the cabinet and

door. Wash them in warm soapy dishwashing water;

rinse in clean water and dry.

Clean the inside with a cloth soaked in warm soapy

dishwashing water. Then, use cold water to wipe off

soapy water.

Wipe the exterior with a soft cloth each time it is soiled.

Clean the Magnetic door seal with a toothbrush and

warm soapy dishwashing water.

Wipe the control panel with the dry cloth.

WHAT TO DO BEFORE YOU CALL FOR SERVICE

Before you call for service, check the following points.

Problem

The outside of a cabinet is hot when

touched.

When there is refrigerator noise.

Frosting or dew generation occurs

inside or outside the refrigerator.

The foods in the refrigerator

compartment freeze.

It smells in the compartment.

IF YOU STILL REQUIRE SERVICE

Refer to your nearest service agent approved by SHARP.

NOTE

•

To prevent damage to your refrigerator, do not use heavy

duty cleansers or solvents (lacquer, paint, polishing powder,

benzine, boiled water, etc.).

•

If the power supply is disconnected, please wait for at least

5 minutes before re-connecting power.

•

The glass shelves weigh approximately 3 kg each. Hold

firmly when removing from the cabinet or carrying.

•

When dropped the juice and the like near the control panel,

wipe off directly. It becomes cause of failure of the control

panel.

•

Do not drop objects inside the refrigerator or strike the inner

wall. This may cause the inner surface to crack.

When the compartment light is blown

Contact the service agent approved by SHARP to request

a replacement compartment light. The compartment light

is not to be removed other than by qualified service

personnel.

Switching off your refrigerator

If you switch your refrigerator off when you are going away

for an extended period, remove all food, clean the interior

thoroughly. Remove the power cord plug from the power

socket and leave all doors open.

It is normal. The hot pipe is in the cabinet in order to prevent dew generation.

It is normal for the refrigerator to produce the following sounds.

• Loud noise produced by the compressor when operation starts

--- Sound becomes quieter after a while.

• Loud noise produced once a day by the compressor

--- Operating sound produced immediately after automatic defrost

operation.

• Sound of flowing fluid (gurgling sound, fizzing sound)

--- Sound of refrigerant flowing in pipes (sound may become louder from

time to time).

• Cracking or crunching sound, squeaking sound

--- Sound produced by expansion and contraction of inner walls and internal

parts during cooling.

This may occur in one of the following cases. Use a wet cloth for wiping frost

and a dry cloth for wiping dew.

• When the ambient humidity is high.

• When the door is frequently opened and closed.

• When foods containing plenty of moisture are stored. (Wrapping is required.)

• Is the refrigerator operated for a long time with refrigerator temp. control set

at 0°C?

• Is the refrigerator operated for a long time with freezer temp. control set at

-21°C?

• Low ambient temperature may cause placed foods to freeze even if

refrigerator temp. control is set to 6°C.

• Wrapping is required for the foods with strong smell.

• Deodorizing unit cannot remove all of smell.

Solution