Sharp PGF267X - XGA DLP Projector Manual de instalación - Página 27
Navegue en línea o descargue pdf Manual de instalación para Proyector Sharp PGF267X - XGA DLP Projector. Sharp PGF267X - XGA DLP Projector 34 páginas. (2500 ansi lumens) short-throw brilliantcolor dlp projector
También para Sharp PGF267X - XGA DLP Projector: Hoja de especificaciones (2 páginas)
Imprimir página
Disconnecting All Connec-
tions
([D]Disconnect All)
It is possible to disconnect all the TCP/IP
connections currently recognized by the
projector. Even if the COM Redirect port is
fi xed in the Busy status due to a problem, it is
possible to force the Ready status back by
carrying out this disconnection.
setup>d
Disconnect All Connections(y/n)?y
Now Disconnecting...
1 Enter "d" and press the "Enter" key.
2 Enter "y" and press the "Enter" key.
Note
•
If Disconnect All is performed, the connection
to the projector via network will be forcibly
disconnected.
Entering ADVANCED
SETUP MENU
([A]Advanced Setup)
Enters ADVANCED SETUP MENU.
setup>a
********************** ADVANCED SETUP MENU *************************
[1]Auto Logout Time
[2]Data Port
[5]Network Ping Test
[6]Accept IP Addr(1)
[7]Accept IP Addr(2)
[9]Accept All IP Addr [0]Search Port
[!]Restore Default Setting
[Q]Return to Main Menu
advanced>
1 Enter "a" and press the "Enter" key.
Setting up the Projector Using RS-232C or Telnet
1
2
1
[8]Accept IP Addr(3)
Setting Auto Logout Time
(ADVANCED[1]Auto Logout Time)
If there is no input after a fi xed time, the
projector automatically disconnects network
connection using the Auto Logout function. It
is possible to set the time until the projector
is automatically disconnected in units of a
minute (from 1 to 65535 minutes).
advanced>1
Valid range
: 0 to 65535 (minute)
note: if you enter "0", auto logout function will be disable.
Auto Logout Time : 5
Please Enter
:15
(change)
—> 15
1 Enter "1" and press the "Enter" key.
2 Enter numerical value and press the
"Enter" key.
Display set numerical value (*).
Note
•
If the set value is made 0, the Auto Logout
function is disabled.
•
If an invalid number is entered, an error
message ("Parameter Error!") will be displayed
and the screen returns to the ADVANCED
SETUP MENU.
Data Port Setting
(ADVANCED[2]Data Port)
Setting of TCP port number. It is possible to
set in the range of 1025 to 65535.
advanced>2
Valid range
:1025 to 65535
Data Port
:10002
Please Enter
:10005
(change)
—>
10005
1 Enter "2" and press the "Enter" key.
2 Enter numerical value and press the
"Enter" key.
Display set numerical value (*).
Note
•
Set according to need. Normally, use with the
factory default setting.
1
2
*
1
2
*
-27