Sharp XG-E1200U Manual de instrucciones - Página 17
Navegue en línea o descargue pdf Manual de instrucciones para Proyector Sharp XG-E1200U. Sharp XG-E1200U 40 páginas.
Connecting to the Computer RGB Input (RGB 1)/Output (RGB 1, 2) Terminals
You can connect your projector to a computer for easy projection of full-color computer images, and an external
monitor for simultaneous viewing.
1
INPUT1
COMPUTER
RGB Signal
Cable
(Supplied)
2
1
Macintosh Adaptor (Supplied)
2
Macintosh Adaptor (Supplied)
Macintosh
RGB Signal
Output Socket
3
Side view of the projector
INPUT1
COMPUTER
RGB Signal
Input Socket
E-17
Side view of the projector
RGB Signal
RGB
OUTPUT
Input Socket
IBM-PC (VGA,
ANALOG RGB OUT
SVGA, XGA)
Series (computer)
RGB Signal
Output Socket
ON
OFF
RGB
OUTPUT
Macintosh
RGB Signal Output Socket
ANALOG
RGB OUT
RGB Signal
Cable
(Supplied)
1. Connecting to an IBM-PC (VGA, SVGA,
XGA) Series computer – 1,024
maximum resolution
Plug the RGB signal cable correctly into the RGB INPUT
terminal on the projector and into the RGB signal output
terminal on the computer, and secure the plugs by
tightening the thumb screws.
Note:
This connection is possible only when using a computer with a
VGA/SVGA/XGA or Mac display output port.
2. Connecting to a Macintosh Series
Computer
640
480 or 832
624 resolution
1 Set the proper switches on the supplied adaptor.
• For 640
480 resolution, set switches 1 and 2 to
"ON" and 3,4,5 and 6 to "OFF".
• For 832
624 resolution, set switches 2 and 4 to
"ON" and 1,3,5 and 6 to "OFF".
2 Connect the supplied Macintosh adaptor to the RGB
signal output terminal on your Macintosh Series
computer, as shown on the left, and secure the plugs
by tightening the thumb screws.
3 Firmly plug the supplied RGB signal cable into both
the RGB input terminal on the projector and the
Macintosh adaptor on the computer, and secure the
plugs by tightening the thumb screws.
Notes:
• Be sure the switches on the adaptor are properly set.
• Once the adaptor is connected to a computer and the com-
puter is turned on, the display mode cannot be changed even
if the switches on the adaptor are reset.
• The supplied adaptor is only for use with H-SYNC and V-
SYNC output. When connecting a Macintosh Series computer
that only outputs C-SYNC, use a special C-SYNC output
adaptor (sold separately).
768