Sharp XG-SV200X Manual de instalación - Página 17

Navegue en línea o descargue pdf Manual de instalación para Proyector Sharp XG-SV200X. Sharp XG-SV200X 26 páginas. Swivel mount projector series
También para Sharp XG-SV200X: Especificaciones (4 páginas), Especificaciones (2 páginas)

Imprimir página
Sharp XG-SV200X Manual de instalación

Controlling the Projector via LAN

After connecting the projector to your network, enter the projector IP address in
"Address" on Internet Explorer (version 6.0 or later) using a computer on the network to
start a setup screen that will enable control of the projector via the network.
Controlling the Projector
Using Internet Explorer
Complete connections to external
equipment before starting the operation.
(See pages 22-26 of the projector's
operation manual.)
Complete the AC cord connection. (See
page 26 of the projector's operation
manual.)
Note
•
When connecting the projector to the LAN, use
a commercially available LAN cable (UTP cable,
Category 5, cross-over type). When
connecting the projector to a hub, use a
straight-through cable.
1
1
Start Internet Explorer on the
computer.
2
2
Enter "http://" followed by the
projector IP address set by the
procedure on page
"/" in "Address", and then press
the "Enter" key.
•
When "DHCP Client" is set to "Off" on the
projector, IP address is 192.168.150.2. If you
did not change the IP address in "3. Setting
up a Network Connection for the
Projector" (pages 15-16), enter
"http://192.168.150.2/".
3
3
A screen for controlling the
projector appears, ready for
performing various status
conditions, control, and settings.
16
followed by
-17