Shimano CJ-8S40 Instrucciones de servicio técnico - Página 2
Navegue en línea o descargue pdf Instrucciones de servicio técnico para Accesorios para bicicletas Shimano CJ-8S40. Shimano CJ-8S40 5 páginas. Cassette joint
Imprimir página
Disconnecting the shifting cable when removing the rear wheel from the frame
Disconnect the cable from the cassette joint when
removing the rear wheel from the frame.
4 0
- 8 S
C J
P A
N
J A
1.
Set the shifting lever to
1
Set to
2.
Hold the rubber cover and pull the outer casing holder
out from the outer casing holder section of the
cassette joint. Then remove the inner cable attached
to the rubber bellows from the slit in the bracket. Be
careful not to damage the rubber bellows at this time.
Rubber bellows
Remove the
rubber bellows
from the slit
Note:
Do not remove the cable by pulling the outer
casing.
Cassette joint
.
1
Pull out the
outer casing
holder
Rubber cover
3.
Remove the inner cable fixing bolt unit from the
cassette joint pulley.
Inner cable fixing bolt unit
Cassette joint pulley
If it is difficult to pull the outer casing holder out
from the outer casing holder section of the
cassette joint, insert a 2 mm Allen key or a #14
spoke into the hole in the cassette joint pulley,
and then turn the pulley to loosen the inner cable.
Then remove the inner cable fixing bolt unit from
the pulley first, and after this remove the outer
casing holder from the outer casing holder
section.
2
Remove the inner
cable fixing bolt unit
CJ-8S40
1
Turn the
Pulley hole
pulley
2 mm Allen key
or #14 spoke
Note:
If reusing the cable, refer to steps 6 to 8 in
"Installation of the shifting cable" .
CJ-8S40
JAPAN
3
Remove the
outer casing
holder
JAPAN