Shimano NEXUS CS-C7000 Manual del Concesionario - Página 17
Navegue en línea o descargue pdf Manual del Concesionario para Bicicleta Shimano NEXUS CS-C7000. Shimano NEXUS CS-C7000 48 páginas.
Imprimir página
Installation/removal
Installing the sprocket (without chain guard)
Installation/removal
Installing the sprocket (without chain guard)
1.
Install the right-hand dust cap, then secure the sprocket with the snap ring.
Check the type, and note the orientation of the right-hand dust cap and sprocket when installing them.
Snap ring
Sprocket
Note the orientation of the sprocket and right-hand dust cap.
Type A
If the sprocket is an inward assembling sprocket with 19T or fewer or for belt drive type, right-hand
dust cap A will come into contact with the chain or pulley so type B should be used instead.
Type B
If the sprocket is an inward assembling sprocket with 16T and 3 mm teeth or for belt drive type,
remove right-hand dust cap B before use.
Outward assembling
Inward assembling
Right-hand dust
cap C
Type A
Type B
Right-hand dust cap
Type A
Type B
Type
A
B
INTER-5E
Right-hand dust
cap B
Applicable sprockets
Outward assembling
16T-23T
24T, 27T, 30T
17
Inward assembling
20T-23T
16T-23T
24T, 27T, 30T