DIGITAL DELAY 1014-SCR Manual de instrucciones - Página 10

Navegue en línea o descargue pdf Manual de instrucciones para Accesorios para automóviles DIGITAL DELAY 1014-SCR. DIGITAL DELAY 1014-SCR 11 páginas.

Wiring and Testing the Unit

To test the four push button inputs and the four yellow L.E.D.s, disconnect all wires going to the

four push button inputs. Next take a piece of wire, connect one end to g

to each of the four push button inputs. As the inputs are touched by the wire the corresponding yellow

L.E.D. should light.

The Crossover Plus with 4-Stage Timer has a built-in test mode for the displays and the red

L.E.D.s. The function key F is held down while the power is being turned on, the unit will go into a test

mode and stay in the test mode until the F key is released.

While in test mode:

The displays will start at "0000" and count up, adding "1111" to the

number shown on both displays every half second.

While the numbers are counting up, the decimal points will switch

back and forth between "00.00" and "0.000" while both the arrows

and colons will flash.

The six red L.E.D.s will flash back and forth every half second.

Both the transbrake and throttle outputs will be off during the test.

round,

then touch the other end