Siemens SIMATIC NET APE1402 Manual de configuración - Página 21
Navegue en línea o descargue pdf Manual de configuración para Equipamiento industrial Siemens SIMATIC NET APE1402. Siemens SIMATIC NET APE1402 36 páginas. Application processing engine
Imprimir página
Configuring and Using the RUGGEDCOM APE
2.3 Upgrading Windows® Embedded Standard 7 Drivers
Note
The GAiA firewall is offered as an alternative to the default firewall that comes on all
RX15xx devices. The GAiA firewall is a widely used and accepted firewall used in en-
terprise and industrial applications and offers easy-to-use management capabilities
for deployments where many firewalls must be set up and maintained. The GAiA fire-
wall may be installed by the factory at the time of ordering or installed in the field us-
ing software obtained from https://www.checkpoint.com/.
Note
Shorewall firewalls are used for Linux distributions. For more information about con-
figuring Shorewall firewalls, refer to http://shorewall.net.
As a one-armed firewall, the external network is supplied by an Ethernet or WAN port
on the RX15xx device. The traffic on this port is restricted to a VLAN shared with the
RUGGEDCOM APE firewall. Traffic inspected and allowed by the RUGGEDCOM APE
firewall is returned to the RX15xx device on other VLANs.
2.3
Upgrading Windows® Embedded Standard 7 Drivers
Windows® Embedded Standard 7 drivers for the Atom-e6xx chip set used on the
RUGGEDCOM APE module can be obtained from Siemens. For more information, con-
tact Siemens Customer Support.
Note
Updated drivers are typically provided with each Linux distribution.
To upgrade the Windows® Embedded Standard 7 drivers, do the following:
1.
2.
3.
4.
5.
6.
7.
8.
12
Obtain a copy of the drivers from Siemens Customer Support.
Extract the files and transfer them to a temporary directory on the RUGGEDCOM
APE module.
Log in to Windows® on RUGGEDCOM APE as an administrator.
For each driver, run setup.exe and follow the instructions provided.
Note
If warned that a driver has not been digitally signed, ignore the warning and
continue with the installation. This is expected behavior.
Reboot the device.
Log in to Windows® on RUGGEDCOM APE as an administrator.
Open Device Manager. A list of detected hardware devices appears.
Verify the new drivers appear in the list of detected hardware devices.
RUGGEDCOM APE (Application Processing Engine)
Configuration Manual, 12/2019, C79000-G8976-1121-05