Siemens SINUMERIK 840D sl Manual de equipamiento - Página 26

Navegue en línea o descargue pdf Manual de equipamiento para Equipamiento industrial Siemens SINUMERIK 840D sl. Siemens SINUMERIK 840D sl 48 páginas. Operator panel front: op 010s
También para Siemens SINUMERIK 840D sl: Instrucciones de actualización (4 páginas), Instrucciones de actualización (5 páginas), Manual de instrucciones (33 páginas), Manual de puesta en servicio (36 páginas), Instrucciones de actualización (3 páginas), Instrucciones de actualización (3 páginas), Manual del sistema (44 páginas), Manual de equipamiento (28 páginas), Manual de equipamiento (26 páginas), Manual de equipamiento (28 páginas)

Mounting

4.3 Assembling an OP 010S and a PCU

Procedure

1. Insert the OP 010S in the panel cutout from the front.

2. Use 8 tension jacks to secure it in the panel cutout from the rear (see Preparation for

mounting (Page 23)).

3. Tighten the setscrews (tightening torque 0.4 - 0.5 Nm).

4.3

Assembling an OP 010S and a PCU

Procedure

1. Position the PCU approximately at right angles to the OP.

2. Insert cable connectors K1 and K2 of the OP into the corresponding counterpieces behind the

opening in the PCU housing.

Ensure that the connectors snap in and that the locks are closed.

3. Fold the PCU onto the OP.

4. Using the four M3 and four M4 screws supplied, attach the PCU to the side of the OP

(tightening torques: M3 0.8 Nm; M4 1.8 Nm).

The clearance at the rear of the PCU must be at least 10 mm to ensure sufficient ventilation

(see Preparation for mounting (Page 23)).

You can find more information on the topic of "heat dissipation" in:

• Chapter "Heat dissipation" (Page 40)

• in the Equipment Manual "PCU 50.5"

Note

The OP 010S and TCU assembly is similar to that for a PCU.

Operator panel front: OP 010S

Equipment Manual, 12/2022, A5E50751046B AA