Cisco 3600 Series Nota de configuración - Página 20

Navegue en línea o descargue pdf Nota de configuración para Teléfono IP Cisco 3600 Series. Cisco 3600 Series 25 páginas. Memory upgrade
También para Cisco 3600 Series: Productos (10 páginas), Instrucciones de actualización (30 páginas), Manual del usuario (17 páginas), Nota de aplicación (41 páginas), Manual de configuración (36 páginas), Manual del usuario (25 páginas), Anexo (15 páginas), Manual del usuario (7 páginas), Manual (5 páginas), Nota de configuración (23 páginas), Nota de configuración (18 páginas)

Upgrading the ROM

Figure 15

Testing ROM Installation

Test your ROM installation by rebooting the router. If you installed the ROM correctly, the router

boots into the ROM monitor or operating system.

Follow these steps if you suspect that the ROM is inserted incorrectly:

Step 1

Step 2

Step 3

Step 4

Step 5

Step 6

If the problem persists, refer to the section "Obtaining Service and Support" later in this document.

20 Cisco 3600 Series Memory Upgrade Conﬁguration Note

Cisco 3640 ROM Location

Remove the cover, as described in the section "Removing the Cover" earlier in this

document.

Gently remove the old ROM with a ROM extraction tool or a small ﬂat-blade screwdriver,

and set it aside.

Use needlenose pliers to straighten any bent pins on the ROM.

Insert the new ROM in its socket in the orientation shown in Figure 14 or Figure 15, being

careful not to bend or crush any of the bottom pins. Align the notch in the new ROM with

the notch in the ROM socket, ignoring the orientation of the label.

Replace the cover, as described in the next section, "Replacing the Cover."

Try booting the router again.

ROM