Siemens XC1003-A Operación - Página 7
Navegue en línea o descargue pdf Operación para Unidad de control Siemens XC1003-A. Siemens XC1003-A 28 páginas. Extinguishing control unit
También para Siemens XC1003-A: Operación (32 páginas)
Imprimir página
Building Technologies
Fire Safety & Security Products
Components and replacement parts
Components and replacement parts procured locally must comply with the
technical requirements defined by the manufacturer. This is ensured in the case
of OEM replacement parts supplied by us.
Use only fuses having the prescribed characteristics.
Incorrect battery types and improper exchange of batteries result in an explosion
hazard. Use only the same battery type or an equivalent type recommended by
us.
Batteries require environmentally appropriate disposal. Bring them to the local
collection centers.
Note that the cylinders containing the extinguishing agent are under pressure
and must be exchanged in accordance with local safety regulations.
Changes to system layout and products
Changes to the system and to individual products may result in faults and incorrect
functioning. Please request from us, from the system installer or from the
respective safety authorities a written authorization for planned changes and
system expansions.
Check serviceability of products
Notify persons in the event of mist and noise.
Notify persons of the testing of the alarm devices and make provisions for
possible panic reactions.
Notify the alarm and fault reception points connected to the system of immanent
test -remote transmission.
When testing the extinguishing system, evacuate the extinguishing area and
block it off.
Electrical installations
Work on electrical systems must be carried out in accordance with electro-
technical rules and only by a trained electrical technician or an instructed
person under the management and supervision of an electrical technician.
DANGER
Work on fittings, on the pipe grid and on devices for supplying extinguishing
agent must be undertaken only by an authorized technician and in compliance
with the technical specifications in force.
When performing work in areas at risk of explosion, comply with the respective
DANGER
safety procedures.
Maintenance work
If you perform maintenance yourself, please observe the following points:
If you require assistance, you must use tools that are safe and intended for the
task such as, for example, a ladder.
If you are triggering fire controls for test purposes, there must be no damage
caused to system components.
Avoid unintended triggering of remote transmission.
Before actuating manual release for test purposes, mechanically block the
activation of extinguishing.
Use or require the use of the "General installation instructions" as the guideline
for extinguishing systems. This guideline is available from us on request.
Safety regulations
7
A6V10099835_a_en
12.2007