Epson 835p - PowerLite XGA LCD Projector Información sobre el producto - Página 14

Imprimir página

Epson 835p - PowerLite XGA LCD Projector Información sobre el producto

Epson PowerLite 835p

NS Connection. If you want to change to a different network

adapter, click

Extension

box, then click

Switch LAN

You see the screen below. (If you have previously started

NS Connection, this is the first screen you see.)

Select projector

If the connection is working properly, you see your

projector listed. If you have additional Epson projectors on

the network, they are also listed, along with their status.

The color of the icon next to each projector's name

indicates its status:

Gray: the projector is not connected

Orange: the projector is connected to another

computer

Green: the projector is connected to your computer

If you don't see your projector, check the following:

Make sure your wireless signal is strong enough to establish

a connection:

If you have a Macintosh, check the

Macintosh menu bar.

For Windows, see the documentation for your access

point or computer network card.

Make sure you're trying to connect to the right network. In

Windows, verify that you've enabled your computer's

connection to the access point or that your wireless card or

adapter is enabled, and that its SSID matches the

projector's ESSID. In Macintosh, check the AirPort status

menu (click the AirPort icon on your menu bar) to make

sure AirPort is turned on and the projector's ESSID or your

AirPort network is selected.

Make sure you aren't projecting one of the EasyMP

configuration screens. (You should see a message that the

projector is ready to connect.) If you have to exit a

configuration screen, restart NS Connection.

Epson PowerLite 835p

on the EMP NS Connection dialog

on the extension dialog box.

icon on the

AirPort

Make sure the ESSID for your projector matches the SSID

for your wireless card, adapter, or access point. If you have

an AirPort base station, make sure the projector's ESSID

matches the AirPort network name. Remember that the

ESSID is case-sensitive.

Note: The AirPort network name may be different than the

AirPort base station name. To check the network name, start

the AirPort Admin utility, select your base station, and click

. Then click

Configure

appears on the AirPort tab.

Check the IP address for both your projector and your

wireless card, adapter, access point, or AirPort base station.

The first three segments of the IP address should be

identical. The last segment of the projector's IP address

should be close, but not identical, to the last segment of the

IP address for your wireless interface, access point, or base

station.

Restart your computer and start NS Connection again.

4. Once the name of your projector appears, select it and click

. If more than one projector is listed, you can select

Connect

additional ones and connect to them at the same time. If

the selected projector is already being used by another

person, you can still connect to it; doing so automatically

disconnects the other user.

Note: If you want your presentation encrypted, click

and select

Extension

enhances security but decreases the data transmission speed.

5. If you set up the projector to prompt you for a keyword

before connecting, you see a screen like this one:

Type in the four-digit number displayed on the EasyMP

Network screen and click

6. Once the connection is established, you see your

computer's image transmitted to the screen, and a floating

control bar on your computer desktop:

7. If necessary, you can drag the control bar out of the way on

your screen.

10/04

. The network name

Show All Settings

Use encrypted communication

Enter

keyword

. This step