Epson 835p - PowerLite XGA LCD Projector Información sobre el producto - Página 5

Imprimir página

Epson 835p - PowerLite XGA LCD Projector Información sobre el producto

The projector's control panel has two

Use the

Computer/Component

button to switch between EasyMP,

and equipment connected to the

ports.

Computer

Use the

Video/S-Video

to switch between equipment

connected to the

Video

ports.

S-Video

The remote control has five

buttons. Use them to

Source

switch between equipment

connected to the port identified on

each button, or select

EasyMP

project wirelessly or from a

memory card.

You can preview all sources to help you select the desired

source, as described below.

The

Computer/Component

input signals, so if you have equipment connected to one of

these ports, be sure to select the correct signal to match the

equipment you're using. You can change the input signal

settings using the projector's menu system.

Previewing Image Sources

Use the preview function to select the image source when you

have connected multiple sources to the projector.

1. Press the

button on the

Preview

remote control.

You see the currently selected

source displayed on the screen,

as shown below. Other sources

(including the currently selected source) appear in smaller

preview windows on the right and bottom of the screen.

Currently selected source

BNC

If no equipment is connected to a port, or if there is no

incoming signal, the preview window for that source

appears blank.

buttons.

Source

™

button

and

ports can be set up to use different

Preview

Computer (Analog-RGB)

Computer

DVI

Video

S-Video

Preview windows

Note: Movies are displayed as still images on the preview

screen.

2. Press the corresponding

control to switch to the desired source. Or press the

button to exit the preview screen without switching sources.

Note: A red border surrounds the preview window for the

currently selected source. You can use the pointer button on

the remote control to select a different source, and then press

to display it.

Enter

What To Do If You See a Blank Screen

If you see a blank screen or a blue screen with the message

after turning on your computer or video source, try

No Signal

the following:

Make sure the cables are connected correctly.

Make sure the

Power

lens cover is off.

Try restarting your computer.

Press the correct

on the remote control. (Allow a few seconds for the

projector to sync up after pressing the button.)

If you're using a PC laptop:

Hold down the

you display on an external monitor. It may have an icon

such as

or it may be labeled

seconds for the projector to sync up after pressing it. Check

your laptop's manual or online help for details.

On most systems, the

toggle between the LCD screen and the projector, or

display on both at the same time.

Depending on your computer's video card, you might need

to use the Display utility in the Windows Control Panel to

make sure that both the LCD screen and external monitor

port are enabled. See your computer's documentation or

online help for details.

10/04

Epson PowerLite 835p

button on the remote

Source

light is green and not flashing and the

button on top of the projector or

Source

key and press the function key that lets

CRT/LCD

key lets you

CRT/LCD

Epson PowerLite 835p

Esc

. Allow a few