Siemens IQ 100 Manual - Página 2
Navegue en línea o descargue pdf Manual para Lavadora Siemens IQ 100. Siemens IQ 100 8 páginas.
También para Siemens IQ 100: Instrucciones de funcionamiento e instalación (43 páginas), Manual de instrucciones de instalación y uso (16 páginas), Manual de instrucciones (12 páginas), Manual de consulta rápida (2 páginas)
Imprimir página
Safety instructions
Care
– Read the instruction manual and installation instructions and all other information enclosed with the washing
machine and act accordingly.
– Retain the documents for subsequent use.
Risk of electric shock
– Never pull the cable to disconnect the mains plug.
– Never insert/disconnect the mains plug with damp hands.
Danger to life
For worn-out appliances:
– Disconnect the mains plug.
– Sever the mains cable and discard along with the plug.
– Destroy the lock on the washing machine door. This will prevent children from
locking themselves in and risking their lives.
Danger of suffocation
– Keep packaging, film and packaging parts out of the reach of children.
Risk of poisoning
– Keep detergents and care products out of the reach of children.
Risk of explosion
– Items of laundry pretreated with cleaning agents containing solvents, e.g. stain
remover/cleaning solvent may cause an explosion after being loaded into the
washing machine.
Rinse items of laundry thoroughly by hand beforehand.
1. Pull the drawer out, press down the insert and fully remove the drawer from the housing.
Risk of injury
– The washing machine door can become very hot.
2. To remove the insert: press the insert upwards from below with your finger.
3. Clean the detergent dispenser tray and insert with water and a brush and dry it. Also remove
– Be careful when draining hot detergent solution.
– Do not climb onto the washing machine.
4. Attach the insert and engage (connect the cylinder to the guide pin).
– Do not lean on the open washing machine door.
5. Push in the detergent drawer.
– Do not reach into the drum if it is still rotating.
– Be careful when opening the detergent drawer while the machine is in operation.
Consumption values
depending on model
Programme
Programme
Load
Electricity**
Water**
duration**
algodón/algodão (cottons) 20 °C
7 kg
0,31 kWh
72 l
2 ¾ h
algodón/algodão (cottons) 40 °C
7 kg
0,85 kWh
72 l
2 ¾ h
algodón/algodão (cottons) 60 °C
7 kg
1,21 kWh
72 l
2 ¾ h
algodón/algodão (cottons) 90 °C
7 kg
2,01 kWh
77 l
3 h
sintéticos (easy-care) 40 °C
3 kg
0,64 kWh
56 l
1 ¾ h
mix 40 °C
3 kg
0,46 kWh
36 l
1 ¼ h
delicado/seda (delicate/silk) 30 °C
2 kg
0,24 kWh
37 l
¾ h
/ lana/lã (wool) 30 °C
2 kg
0,22 kWh
47 l
¾ h
1. Turn the programme selector to
Additional
Annual energy
Annual water
Programme
Load
2. Drain the detergent solution
function
consumption
consumption
3. Pull the emergency release downwards with a tool and release.
algodón/algodão (cottons) 40 / 60 °C
ecoPerfect*
3,5/7 kg
165 kWh
10686 l
* Programme setting for testing and energy labelling in accordance with EU directive 2010/30/EU with cold water (15 ºC).
** The values deviate from the indicated values depending on water pressure, hardness, and inlet temperature, ambient tem-
perature, type, amount and soiling of the laundry, detergent used, fluctuations in the power supply and selected additional
functions.
8
8
7
– Risk of electric shock.
Maintenance
Disconnect the mains plug.
– Risk of explosion. No solvents.
Before washing for the first time
Detergent solution pump
Do not load any laundry into the machine. Turn on the tap.
Turn the programme selector to
Add the following to compartment II:
1. Open and remove the service flap.
– approx. 1 litre water
– detergent (dosage according to the manufacturer's instructions for light soiling and the appropriate degree of water
hardness)
Set the programme selector to algodón/algodão (cottons) 60 °C and select inicio/pausa (start/pause). At the end of
2. For models with a drainage hose: Remove the drainage hose from the
the programme, turn the programme selector to
(off).
retainer and pull it from the housing. Remove the container.
Machine housing, control panel
Remove the sealing cap, allow the detergent solution to flow out.
Replace the sealing cap and place the drainage hose in the retainer.
– Wipe with a soft, damp cloth.
– Do not use any abrasive cloths, scourers or cleaning agents (stainless steel cleaners).
2* For models without a drainage hose: Carefully unscrew the pump cover
– Remove detergent and cleaning agent residue immediately.
until the detergent solution begins to flow out. When the service flap is
– Do not clean with a jet of water.
half full, close the pump cover and empty the service flap. Repeat the
above steps until all the detergent solution has completely drained out.
Cleaning the detergent drawer and housing...
... if it contains detergent or fabric softener residues.
3. Carefully unscrew the pump cover (residual water).
4. Clean the interior, pump cover thread and pump housing (the impeller in
the detergent solution pump must rotate).
5. Replace the pump cover and screw it tightly.
any detergent or fabric softener residues in the housing.
6. Place the service flap back on and close.
Leave the detergent drawer open so that any residual water can evaporate.
To prevent unused detergent from flowing straight into the drain during the next wash:
Pour 1 litre of water into compartment II and start the
Washing drum and rubber seal
Drainage hose at the siphon
Wipe the inside of the rubber seal dry with a cloth. Leave the washing machine door open so that the drum can dry out.
Turn the programme selector to
Rust stains - use chlorine-free cleaning agent, not steel wool.
1. Loosen the hose clamp, carefully remove the drainage hose
Descaling
Ensure there is no laundry in the machine
(residual water).
2. Clean the drainage hose and siphon connecting piece.
Descale the appliance according to the descaler manufacturer's instructions. This should not be necessary if the
3. Reattach the drainage hose and secure the connection with the hose
correct dosage of detergent is used.
clamp.
Emergency release, e.g. in the event of a power cut
Filter in the water supply
The programme continues to run when the power has been restored. However, if the laundry has to be removed, the
Risk of electric shock
washing machine door can be opened as follows:
Do not immerse the AquaStop safety device in water (contains an electric valve).
Risk of scalding.
The detergent solution and laundry may be hot. If possible, leave it to cool down.
Reduce the water pressure in the supply hose:
Do not reach into the drum if it is still rotating.
Do not open the washing machine door if water can be seen through the glass.
1. Turn off the tap.
(o ff) and disconnect the mains plug.
2. Select any programme (except
(empty)).
page 10.
3. Select inicio/pausa (start/pause). Let the programme run for
Washing machine door can then be opened.
approximately 40 seconds.
4. Turn the programme selector to
Clean the filter:
1. Depending on model:
Disconnect the hose from the tap.
Clean the filter using a small brush.
and/or for Standard and AquaStop models:
Remove the hose on the rear of the appliance,
Remove the filter with pliers and clean.
2. Connect the hose and check for leaks.
9
– Risk of scalding. Allow the
What to do if ...
detergent solution to cool down.
– Turn off the tap.
Water is leaking out.
– Attach/replace the drainage hose correctly.
– Tighten the screw connection of the supply hose.
(off) and disconnect the mains plug.
No water supply.
– inicio/pausa (start/pause) not selected?
Detergent not
– Tap not turned on?
dispensed.
– Filter blocked? Clean the filter
– Supply hose kinked or trapped?
Washing machine door
– Safety function active. Wait approx. 2 minutes.
cannot be opened.
– - - - - (without final spin) selected?
– Can be opened by emergency release only?
Programme does not
– inicio/pausa (start/pause) or
start.
– Washing machine door closed?
– Childproof lock active? Deactivate
Detergent solution is
– - - - - (without final spin) selected?
not drained.
– Clean the detergent solution pump
– Clean the waste pipe and/or drainage hose.
Water not visible in the
– Not a fault - water below the visible area.
drum.
Unsatisfactory spin
– Not a fault - the unbalanced-load detection system has cancelled the
result.
spin cycle because of uneven distribution of the laundry. Distribute
Laundry wet/too damp.
small and large items of laundry evenly inside the drum.
– Programme
menos (anti-crease) selected?
– Speed selected too low?
The programme
– Not a fault – the programme sequence is optimised for the particular
duration changes
wash process. This may result in changes to the programme
during the wash cycle.
duration in the display field.
Spin cycle performed
– Not a fault - unbalanced load detection system adjusts the
(empty) programme.
several times.
imbalance.
Residual water in the
– Not a fault - the action of the care product is not affected.
(off) and disconnect the mains plug.
compartment for care
– Clean the insert if necessary
products.
Odour formation in the
– Run programme algodón/algodão (cottons) 90 °C without laundry.
washing machine.
Use standard detergent.
activo (wash) display
– Too much detergent used? Mix 1 tablespoon of fabric softener with
lamp flashes. Foam
½ litre of water and pour into dispenser II (not for outdoor and down-
may be coming out of
filled textiles!).
the detergent drawer.
– Reduce the detergent dosage for the next wash cycle.
Intense noise formation,
– Are the appliance feet fixed? Secure the appliance feet
vibrations and
Installation instructions.
"wandering" during the
– Transportation safety devices removed? Remove the transportation
spin cycle.
safety devices
Installation instructions.
Noises during spin and
– Clean detergent-solution pump
drain cycles.
(rinse)/
centrifug. (spin) //
Display panel/indicator
– Power cut?
lamps do not function
– Fuses triggered? Reset/change the fuses.
during operation.
– If the fault occurs repeatedly, call the after-sales service.
(off). Disconnect the mains plug.
Programme sequence
– Not a fault - unbalanced load detection system adjusts imbalance by
longer than usual.
repeatedly distributing the laundry.
– Not a fault - foam detection system active - adds an additional rinse
cycle.
Detergent residues on
– Occasionally, phosphate-free detergents contain water-insoluble
the laundry.
residues.
– Select
(rinse)/
centrifug. (spin) or brush the laundry after
washing.
If you cannot correct a fault yourself (switching on/off) or a repair is required:
– Turn the programme selector to
(off) and remove the mains plug from the socket.
– Turn off the water supply and call the after-sales service
10
page 10.
page 3, 4.
page 9.
(finished in) selected?
page 5.
page 3, 4.
page 10.
page 7.
page 5.
page 9.
Washing machine
WM14E267ES ...
page 10.
siemens-home.com/welcome
en Washing machine
operating instructions
Observe the safety instructions on page 8.
Read these instructions and the separate installation
instructions before operating the washing machine.
Installation instructions.
11
Register
your
product
online