Siemens WM T Series Manual de instrucciones e instrucciones de instalación - Página 17
Navegue en línea o descargue pdf Manual de instrucciones e instrucciones de instalación para Lavadora Siemens WM T Series. Siemens WM T Series 46 páginas.
Imprimir página
Electrical connection
:
Warning
Danger of death!
There is a risk of electric shock if you
touch live components.
Never touch or hold the mains plug
■
with wet hands.
Only pull out the mains cable by the
■
plug and never by the cable, as this
could damage it.
Never unplug the mains plug during
■
operation.
Observe the following information and
ensure that:
Notes
The mains voltage and voltage
■
indicated on the washing machine
(rating plate) are the same.
The connected load and fuse
required are specified on the rating
plate.
The washing machine is only
■
connected to an alternating current
via a properly installed earthed
socket.
The mains plug fits the socket.
■
The cable cross-section is adequate.
■
The earthing system is properly
■
installed.
The mains cable is only replaced by
■
a qualified electrician (if this is
necessary). Replacement mains
cables are available from the after-
sales service.
No multiple plugs/couplings or
■
extension cables are used.
If an earth-leakage circuit breaker is
■
used, only a type which displays this
symbol is used: z.
Only this symbol guarantees
compliance with the currently
applicable regulations.
Positioning and connecting
The mains plug must be freely
■
accessible at all times. If this is not
possible, in order to comply with the
relevant safety regulations, a switch
(2-pole switch-off) must be built into
the permanent installation in
accordance with electrical
installation regulations.
The mains cable is not bent,
■
squashed, modified, cut through, or
in contact with heat sources.
Before washing for the first
time
The washing machine has been
thoroughly tested before leaving the
factory.To remove any water that may
be left over from testing, run the first
wash cycle without any laundry.
Notes
The washing machine must be
■
correctly installed and connected.
See ~ Page 12 onwards
Never use a damaged machine.
■
Notify your after-sales service.
Preparatory work:
Check the machine.
1.
Fill the ¨ and M dispensers.
2.
~ Page 33
Remove the protective film from the
3.
control panel.
Plug in the mains plug.
4.
Turn on the tap.
5.
Run the program without laundry:
Switch on the appliance.
1.
Close the door (do not load any
2.
laundry).
Set the Drum Clean 90 °C program.
3.
Open the detergent drawer.
4.
Pour approx. 1 litre of water into the
5.
manual dosing compartment.
Pour all-purpose detergent into the
6.
manual dosing compartment.
en
17