Siemens WM10K161GR Manual de instrucciones e instrucciones de instalación - Página 22
Navegue en línea o descargue pdf Manual de instrucciones e instrucciones de instalación para Lavadora Siemens WM10K161GR. Siemens WM10K161GR 38 páginas.
Imprimir página
Cleaning and maintenance
en
Remove the detergent residue
■
immediately.
Do not clean with a water jet.
■
Drum
Use chlorine-free cleaning agents and
not steel wool.
Descaling
Descaling should not be necessary if
the detergent is measured out correctly.
However, if it is required, follow the
manufacturer's instructions for the
descaling agent. Suitable descalers can
be obtained via our website or from our
after-sales service.
Detergent drawer and housing
If the washing machine contains
detergent or fabric softener residues:
Pull out the detergent drawer. Press
1.
down the insert and fully remove the
drawer.
To remove the insert: Push the insert
2.
upwards from below with your finger.
Clean the detergent dispenser tray
3.
and insert with water and a brush,
and dry it. Clean the inside of the
housing as well.
Fit the insert and lock it in place
4.
(push the cylinder onto the guide
pin).
Push in the detergent drawer.
5.
Leave the detergent drawer open
Note:
so that any residual water can
evaporate.
22
Detergent solution pump
blocked
:
Warning
Risk of scalding!
When you wash at high temperatures,
the water gets very hot. If you come into
contact with the hot water, you may be
scalded.
Allow the water to cool down.
Turn off the water tap so that no
1.
more water can flow in and has to be
drained via the drain pump.
Switch off the appliance. Disconnect
2.
the mains plug.
Open and remove the service flap.
3.
Take the drain hose out of the
4.
retainer.
Remove the sealing cap, allow the
detergent solution to flow out into a
suitable container.
Replace the sealing cap and place
the drainage hose in the retainer.
Carefully unscrew the pump cover,
5.
residual water may leak out.
Clean the interior, pump cover
thread and pump housing. The
impeller in the detergent solution
pump must be able to rotate.
Refit the pump cover and screw it on
tightly. The handle must be in a
vertical position.