Siemens WM12W460IL Manual de instrucciones e instrucciones de instalación - Página 27

Navegue en línea o descargue pdf Manual de instrucciones e instrucciones de instalación para Lavadora Siemens WM12W460IL. Siemens WM12W460IL 44 páginas.

Imprimir página
Carefully unscrew the pump cover;
5.
residual water may leak out.
Clean the interior, pump-cover
thread and pump housing. The
impeller in the drain pump must be
able to rotate.
Refit the pump cover and screw it on
tightly. The handle must be in a
vertical position.
Place the service flap back on, lock
6.
it into place, and close it.
To prevent unused detergent
Note:
from flowing straight into the drain
during the next wash: Pour 1 litre of
water into compartment II and start the
Empty programme.
Cleaning and maintenance
The drain hose at the siphon
is blocked
Switch off the appliance. Pull out the
1.
mains plug.
Loosen the hose clamp. Carefully
2.
remove the drain hose; residual
water may leak out.
Clean the drain hose and siphon
3.
connecting piece.
Re-attach the drain hose and secure
4.
the connection point using the hose
clamp.
Filter in the water supply
blocked
First, reduce the water pressure in the
supply hose:
Turn off the tap.
1.
Select any programme (except
2.
Rinse/Spin/Empty).
Press the Ü button. Allow the
3.
programme to run for approximately

40 seconds.

Press the # button. The appliance is
4.
switched off.
Pull out the mains plug.
5.
Then clean the filter:
Disconnect the hose from the tap.
1.
Clean the filter with a small brush.
en
27