Siemens XQG80-WM12P1681W Manual de instrucciones e instrucciones de instalación - Página 36
Navegue en línea o descargue pdf Manual de instrucciones e instrucciones de instalación para Lavadora Siemens XQG80-WM12P1681W. Siemens XQG80-WM12P1681W 40 páginas.
Imprimir página
Installation and connection
en
Alignment
Loosen lock nut in a clockwise
1.
direction with a wrench.
Check alignment of the washing
2.
machine with a spirit level and, if
required, correct. Adjust the height
by rotating the foot.
All four feet must be firmly on
Note:
the floor.
The washing machine must not
wobble!
Tighten the lock nut against the
3.
housing.
Grip the foot and do not adjust the
height.
Notes
– The lock nuts on all four
appliance feet must be screwed
tightly against the housing!
– Loud noise formation, intense
vibrations and "wandering" may
be due to incorrect alignment!
Electrical connection
Electrical safety
:
Warning
Danger of death from electric shock!
Danger of death if live parts are
touched.
Never pull out the mains plug by
■
tugging the power cord.
Insert/pull out the mains plug with
■
dry hands only.
Never pull out the mains plug during
■
operation.
Connect the washing machine to an
■
alternating current via a correctly
installed earthed socket only.
36
The mains voltage and voltage
■
specifications on the washing
machine (appliance rating plate)
must match.
Connected load as well as required
■
fuse are indicated on the appliance
rating plate.
Ensure that:
the mains plug and socket match,
■
the cable cross-section is adequate,
■
earthing system has been installed
■
correctly.
A damaged power cord may
■
be replaced by an electrician only.
A replacement mains cable can be
obtained from customer service.
Do not use multiple plugs/couplings
■
or extension cables.
If a residual-current-operated circuit
■
breaker is used, use only a type
which features this symbol: z.
Only this symbol guarantees
compliance with the currently valid
regulations.
The mains plug must be accessible
■
at all times.
Before washing for the first
time
The washing machine was inspected
thoroughly before leaving the factory. To
remove any residual test water, run the
(Drum clean) 90°C programme
the first time without washing.
The washing machine must have
Note:
been installed and connected properly.
See chapter Installing ~ Page 32
Insert mains plug.
1.
Turn the tap on.
2.
Close the washing machine door.
3.
Do not load any washing.
Select
(Drum clean) 90°C
4.
programme.
Open the detergent drawer.
5.
Pour approx. 1 litre of water into
6.
dispenser II.