Cisco 7925G - Unified Wireless IP Phone VoIP Manual de instalación - Página 17

Navegue en línea o descargue pdf Manual de instalación para Teléfono IP Cisco 7925G - Unified Wireless IP Phone VoIP. Cisco 7925G - Unified Wireless IP Phone VoIP 21 páginas. Wavelink avalanche management console
También para Cisco 7925G - Unified Wireless IP Phone VoIP: Ficha de datos (8 páginas), Notas de publicación (16 páginas), Manual del usuario (28 páginas), Manual de accesorios (20 páginas), Manual de accesorios (13 páginas), Manual de administración (19 páginas), Manual del usuario (10 páginas), Manual del usuario (16 páginas), Manual rápido (14 páginas), Manual de administración (23 páginas), Manual de administración (14 páginas)

Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G Setup

Bulk Provisioning

The Cisco Unified Wireless IP Phones support a Bulk Provisioning Utility. For more information, see the

Bulk Deployment Utility Guide at

792xBD.1-0-Readme.pdf.

Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G

Startup

After charging the battery and configuring the wireless IP phone, you are ready to power on the phone and

connect to the WLAN.

To power on the Cisco Unified Wireless IP Phone, press and hold the Power On button until the phone begins

its startup process by cycling through these steps:

1 The phone displays the Cisco Systems screen.

2 The phone screen displays these messages as the phone starts up:

3 The following information displays on the main phone screen:

When the phone passes through these stages with no errors, the phone has started up properly. Now the phone

is in standby mode and is ready to place or receive calls.

The signal icon in the upper left corner shows the strength of the signal between the wireless access point and

the phone. The phone must have an adequate signal to successfully place or receive calls. If the signal icon

displays only one bar, the weak signal can cause problems with phone performance.