Siemens dishwasher Manual de instrucciones - Página 24

Navegue en línea o descargue pdf Manual de instrucciones para Lavavajillas Siemens dishwasher. Siemens dishwasher 28 páginas. Dishwasher
También para Siemens dishwasher: Manual de instrucciones (29 páginas), Manual de instrucciones (30 páginas), Manual de instrucciones (30 páginas), Manual de instrucciones (30 páginas), Manual de instrucciones (26 páginas), Manual de instrucciones (28 páginas), Manual de instrucciones (26 páginas), Manual de instrucciones (28 páginas), Manual de instrucciones (32 páginas), Manual de instrucciones (28 páginas), Manual de instrucciones (34 páginas), Manual de instrucciones (34 páginas), Manual de instrucciones (28 páginas), Manual de instrucciones (34 páginas), Manual de instrucciones (26 páginas), Manual de instrucciones (40 páginas), Manual de instrucciones (31 páginas), Manual de instrucciones (40 páginas), Manual de instrucciones (24 páginas), Manual de instrucciones (28 páginas), Manual de instrucciones (28 páginas)

Imprimir página
Siemens dishwasher Manual de instrucciones
en

Waste-water connection

– The required work sequence can be
found in the installation instructions. If
required, fit a siphon with an drainage
connection.
– Connect the waste-water hose to the
drainage connection of the siphon with
the enclosed parts.
Ensure that the drainage hose is not
kinked, crushed or twisted and that
there is no cover plate in the drainage
to prevent the waste water from flowing
out!

Fresh water connection

– Connect the fresh-water connection to
the tap according to the installation
instructions with the enclosed parts.
Ensure that the fresh-water connection
is not kinked, crushed or twisted.
– When replacing the appliance, always
use a new water supply hose.
Water pressure:
at least 0.05 MPa (0.5 bar), maximum
1 MPa (10 bar). At a higher water
pressure: connect pressure-reducing valve
ahead.
Inlet rate:
minimum 10 litres/minute
Water temperature:
cold water preferred; hot water max.
temperature 60 °C.
24

Electrical connection

– Connect the appliance only to 230 V
and 50 Hz alternating current via
a correctly installed socket with
protective conductor. See rating plate
for required fusing 9*.
– The socket must be near the appliance
and freely accessible following
installation.
– The connection may be modified by
technicians only.
– A power cord extension may be
purchased from customer service only.
– Use only a residual current operated
circuit-breaker which features
the symbol ‚. Only this extension
guarantees compliance with
the currently valid regulations.

Removing the appliance

Also observe the sequence of worksteps
here.
– Disconnect the appliance from
the power supply.
– Turn off the water supply.
– Disconnect the waste water and fresh
water connections.
– Loosen fastening screws for the
furniture parts.
– If fitted, remove the base panel.
– Pull out the appliance, carefully pulling
the hose behind.